PIC16C72A-04/SO Microchip Technology Inc., PIC16C72A-04/SO Datasheet - Page 17

• Manufacturer Part Number: PIC16C72A-04/SO
• Description: 28 PIN, 3.5 KB OTP, 128 RAM, 22 I/O
• Manufacturer: Microchip Technology Inc.

Specifications of PIC16C72A-04/SO

• A/d Inputs: 5-Channel, 8-Bit
• Cpu Speed: 5 MIPS
• Eeprom Memory: 0 Bytes
• Input Output: 22
• Memory Type: OTP
• Number Of Bits: 8
• Package Type: 28-pin SOIC
• Programmable Memory: 3.5K Bytes
• Ram Size: 128 Bytes
• Speed: 4 MHz
• Timers: 2-8-bit, 1-16-bit
• Voltage, Range: 2.5-5.5 V
• Lead Free Status / Rohs Status: RoHS Compliant part Electrostatic Device

2.3
The program counter (PC) specifies the address of the
instruction to fetch for execution. The PC is 13 bits
wide. The low byte is called the PCL register and is
readable and writable. The high byte is called the PCH
register. This register contains the PC<12:8> bits and
is not directly accessible. All updates to the PCH regis-
ter go through the PCLATH register.
2.3.1
The stack allows any combination of up to 8 program
calls and interrupts to occur. The stack contains the
return address from this branch in program execution.
Mid-range devices have an 8 level deep hardware
stack. The stack space is not part of either program or
data space and the stack pointer is not accessible. The
PC is PUSHed onto the stack when a CALL instruction
is executed or an interrupt causes a branch. The stack
is POPed in the event of a RETURN, RETLW or a RET-
FIE instruction execution. PCLATH is not modified
when the stack is PUSHed or POPed.
After the stack has been PUSHed eight times, the ninth
push overwrites the value that was stored from the first
push. The tenth push overwrites the second push (and
so on).
1999 Microchip Technology Inc.
PCL and PCLATH
STACK
Preliminary
2.4
The CALL and GOTO instructions provide 11 bits of
address to allow branching within any 2K program
memory page. When doing a CALL or GOTO instruction,
the upper bit of the address is provided by
PCLATH<3>. The user must ensure that the page
select bit is programmed to address the proper pro-
gram memory page. If a return from a CALL instruction
(or interrupt) is executed, the entire 13-bit PC is popped
from the stack. Therefore, manipulation of the
PCLATH<3> bit is not required for the return instruc-
tions.
Program Memory Paging
PIC16C62B/72A
DS35008B-page 17