SLCF2GM2TU-S STEC, SLCF2GM2TU-S Datasheet - Page 55
![no-image](/images/no-image-200.jpg)
SLCF2GM2TU-S
Manufacturer Part Number
SLCF2GM2TU-S
Description
Manufacturer
STEC
Datasheet
1.SLCF2GM2TU-S.pdf
(69 pages)
Specifications of SLCF2GM2TU-S
Lead Free Status / Rohs Status
Compliant
SLCFxxxM2TU(I)(-x)
Datasheet
6.2
Data Register
Error Register
Sector Count Register
Sector Number Register
Cylinder Low Register
Cylinder High Register
Drive/Head Register
Status Register
Alternate Status Register
Device Control Register
Drive Address Register
Command Register
Task File Register
Task File Registers
The Data Register is a 16-bit read/write register used for transferring data
between the CF Card and the host. This register can be accessed in word
mode and byte mode.
The Error Register is a read-only register that is used for analyzing an error.
This register is valid when the BSY bit in the Status register and Alternate
Status register are set to ―0‖ (Ready). Diagnostic Codes are returned in the
Error Register after an EXECUTE DRIVE DIAGNOSTIC command (code 90h).
Extended Error Codes returned in the Error Register after a REQUEST SENSE
command (code 03h).
This register contains the numbers of sectors of data requested to be
transferred on a read or write operation between the host and the CF Card. If
the value in the register is 0, a count of 256 sectors is indicated.
When the LBA bit in the Drive/Head register is 0, this register contains the
starting sector number for any media access. When the LBA bit is set to 1, this
register contains bits 7:0 of the LBA for any media access.
In CHS mode (LBA=0), this register contains the low-order bits of the starting
cylinder address. In LBA mode, it contains bits 15:8 of the LBA.
In CHS mode (LBA=0), this register contains the high-order bits of the starting
cylinder address. In LBA mode, it contains bits 23:16 of the LBA.
This register selects the CF Card address translation (CHS or LBA) and
provides head address (CHS) or high-order address bits 27:24 for LBA.
This read-only register indicates status of a command execution. When the
BSY bit is ―0‖, the other bits are valid; when the BSY bit is ―1‖, the other bits
are not valid. When the register is read, the interrupt pin is cleared.
This register is the same as the Status register, except that is not negated
when the register is read.
This write-only register is used for controlling the interrupt request and issuing
an ATA soft reset to the CF Card.
This read-only register is used for confirming the CF Card’s status. This
register is provided for compatibility with the AT disk drive interface and it is
not recommended that this register be mapped into the host’s I/O space
because of potential conflicts on bit 7.
This write-only register is used for writing the command that executes the CF
Card’s operation. The command code is written in the command register after
its parameters are written in the Task File during the CF Card ready state.
Table 29: CF Card Task File Registers
61000-07000-104, April 2011
Description
CompactFlash Card
55