R88A-CAU001 Omron, R88A-CAU001 Datasheet - Page 76
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
R88A-CAU001
Manufacturer Part Number
R88A-CAU001
Description
POWER CABLE CE W/CABLE 1M
Manufacturer
Omron
Datasheet
1.R88A-CAU001.pdf
(324 pages)
Specifications of R88A-CAU001
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
R88ACAU001
- Current page: 76 of 324
- Download datasheet (3Mb)
Design and Installation
j Point Selection 0 to 6 [UP-01 (Control Mode) = 11 or 12]
j Positions 0 to 7 [UP-01 (Control Mode) = 13 or 14]
DIO
P.IN0 to 7
DIO
STOP
DIO
BO
This is the signal input for selecting positioning data from PTP data.
The range of data is 1 to 64, in BCD.
Point selections 0 to 3 become the data input for digit 10
input for digit 10
This is the positioning data signal input.
The range of data is 0 to 99, in BCD (up to a maximum of “F9,” for the position’s leftmost digits only).
The 32 bits for the position data and the 8 bits for the speed data are taken eight bits at a time. At this
time the position and speed selection signals (P.OUT 0 to 4) are output as data request signals. Re-
fresh the input data according to the data request signals.
If the speed is set to “0,” it will be taken as 100%.
This is the signal input for forcibly stopping motor rotation.
While this signal is not being input (ON), the motor cannot be driven.
With the CompoBus/S Position Drivers, the motor cannot be driven unless the external control signal
input (CN4-4) and the CompoBus/S input (OUT7) are both input.
The method for stopping the motor depends on the set value for PP-24 (deceleration stop mode).
When UP-16 (brake mode) is set to 1, 2, or 3 (brake retention), the timing signal for applying the elec-
tromagnetic brake is output. If the motor’s rotation speed falls below the UP-28 (brake-ON r/min) set
value under the following circumstances, the output will be turned OFF and the electromagnetic brake
will be operated.
When UP-16 is set to 0 (dynamic brake), the timing signal for applying the dynamic brake is output.
Under the following circumstances the output is turned OFF and the dynamic brake is operated.
Control Output Details
Example: When point No. 12 is set.
When the RUN signal has been turned OFF.
When an error shutting OFF the power to the motor has occurred.
When a deceleration stop turns OFF while PP-24 (deceleration stop mode) is set to 0 (free-run
stop).
1
.
Point selection
CN1-11 to 18
Point selection / Position data
CN1-20
Deceleration stop
CN1-21
Brake output
6
0
CompoBus/S
CompoBus/S
CompoBus/S
5
0
4
1
3
0
2
0
0
, and point selections 4 to 6 become the data
1
1
OUT8 to 15
CN4-4 / OUT7
CN4-8 / IN0
0
0
0: OFF, 1: ON
N.O. condition
N.C. condition
Chapter 2
2-53