DCN3-12 Omron, DCN3-12 Datasheet - Page 96
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
DCN3-12
Manufacturer Part Number
DCN3-12
Description
M18 SHIELDEDTCNCTR M12 BRNCH
Manufacturer
Omron
Datasheet
1.XW4B-05C4-TF-D.pdf
(166 pages)
Specifications of DCN3-12
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
DCN312
- Current page: 96 of 166
- Download datasheet (4Mb)
Wiring Methods
1,2,3...
Note
■
■
Attaching the Cable
Pressure-welding the Connector
Align the indications on the cable identification label with the cable colors and
insert the cable. The cover is translucent, so it is possible to confirm that the
cable has been inserted all the way in.
Use the DWT-A01 Pliers to pressure-weld the connector.
1. As shown in the following diagram, align the center of the connector cover
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
3. After attaching the cable, confirm that it is properly pressure-welded as
(1) Do not pressure-weld the connector cover at the edges.
(2) Do not pressure-weld the connector cover at the back of the pressure-
(3) Set the connector in the correct orientation.
(see arrows) with the center of the pressure-welding block on the Pliers.
place.
shown below.
Pliers
welding block.
OK
Be sure there are no gaps here.
NG
Confirm that the cable has
been inserted up to this position.
Connector cover
NG
NG
Section 2-4
75