NS7-KBA04 Omron, NS7-KBA04 Datasheet - Page 139
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
NS7-KBA04
Manufacturer Part Number
NS7-KBA04
Description
ANTI-GLARE SHEET FOR NS7 5PC
Manufacturer
Omron
Datasheet
1.NS12-TS01B-V2.pdf
(334 pages)
Specifications of NS7-KBA04
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
NS7KBA04
- Current page: 139 of 334
- Download datasheet (7Mb)
Connecting to CS-series Serial Communications Boards
Serial Communications Boards with RS-232C Port for Use with CS-series CPU Units:
CPU Unit DM Area Settings
Write the settings directly from the Programming Device (Programming Console) or Support
Software (CX-Programmer) to the DM Area (Parameter Area) in the CPU Unit. After writing
the settings, enable the settings by turning ON the power again, restarting the Unit, restart-
ing the communications port, or executing the CHANGE SERIAL PORT SETUP (STUP) in-
struction.
The following table shows the allocated DM Area words and settings. The settings are the
same for RS-232C and RS-422A (CS1W-SCB41 Port 2).
Note: When connecting a single Unit in a 1:N connection, set the value of @ to 1 or higher.
For example, to connect PTs with unit numbers 3 to 6 to Port 1 in 1:N NT Links, set
DM32000 to 8200 Hex, DM32001 to 000A Hex, and DM32006 to 0006 Hex.
Serial Communications Boards with RS-422A Port for Use with CS-series CPU Units:
Reference
Reference
Allocated DM Area words
DM32000
DM32001
DM32006
Port 1
CS1W-SCB21 (Both ports 1 and 2 are RS-232C ports.)
CS1W-SCB41 (Port 1 is an RS-232C port and Port 2 is an RS-422A port.)
CS1W-SCB41 (Port 2 is an RS-422A port.)
High-speed 1:N NT Links can be used with Serial Communications Boards and Serial
Communications Units from lot numbers 991220 (December 20, 1999) or later. Boards
and Units with earlier lot numbers cannot be used, so confirm that the lot number is sup-
ported.
To set high-speed 1:N NT Link communications from the CX-Programmer, set the baud
rate to 115,200 bps.
DM32010
DM32011
DM32016
Port 2
Write
value
000@
000A
8200
1:N NT Link Mode
Baud rate (high-speed)
@: Largest unit number (1 to 7) of the connected PTs. (See
note.)
Settings
4-3 High-speed 1:N NT Link
4-23