CV500-CN22A Omron, CV500-CN22A Datasheet - Page 57
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
CV500-CN22A
Manufacturer Part Number
CV500-CN22A
Description
CONNECTING CABLE 2M
Manufacturer
Omron
Datasheet
1.R88A-CAU001.pdf
(324 pages)
Specifications of CV500-CN22A
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
CV500CN22A
- Current page: 57 of 324
- Download datasheet (3Mb)
Design and Installation
j Keeping Foreign Objects Out of Units
j Operating Environment
Be sure that the environment in which the Servomotor is operated meets the following conditions.
j Impact and Load
j Connecting to Mechanical Systems
2-34
Place a cover over the Units or take other preventative measures to prevent foreign objects, such as
drill filings, from getting into the Position Driver during installation. Be sure to remove the cover after
installation is complete. If the cover is left on during operation, heat buildup may damage the Driver.
Take measures during installation and operation to prevent foreign objects such as metal particles,
oil, machining oil, dust, or water from getting inside of the Position Driver.
AC Servomotors
Ambient operating temperature:
Ambient operating humidity: OMNUC U Series: 20% to 80% (RH, with no condensation)
Atmosphere:
The Servomotor is resistant to impacts of up to
98 m/s
loads during transport, installation, or positioning. In
addition, do not hold onto the encoder/resolver
area, cable, or connector areas when transporting it.
Always use a pulley remover to remove pulleys,
couplings, or other objects from the shaft.
Secure cables so that there is no impact or load placed on the cable connector areas.
The axial loads for Servomotors are specified in sec-
tion 5-2 Servomotor Specifications . If an axial load
greater than that specified is applied to a Servomo-
tor, it will reduce the service life of the motor bearings
and may damage the motor shaft. When connecting
to a load, use couplings that can sufficiently absorb
mechanical eccentricity and variation.
Recommended Coupling
For spur gears, an extremely large radial load may
be applied depending on the gear precision. Use
spur gears with a high degree of accuracy (for exam-
ple, JIS class 2: normal line pitch error of 6 m max.
for a pitch circle diameter of 50 mm). If the gear preci-
sion is not adequate, allow backlash to ensure that
no radial load is placed on the motor shaft.
Oldham coupling
2
Name
{10 G}. Do not subject it to heavy impacts or
Myghty Co., Ltd
OMNUC U-UE Series: 20% to 80% (RH, with no condensation)
OMNUC H Series: 35% to 85% (RH, with no condensation)
OMNUC M Series: 35% to 85% (RH, with no condensation)
No corrosive gases.
Maker
0 C to +40 C
Motor shaft center line
Backlash
Shaft core
displacement
Ball screw center line
Adjust backlash
by adjusting the
distance between
shafts.
Chapter 2