R88A-CAWE020B Omron, R88A-CAWE020B Datasheet - Page 236
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
R88A-CAWE020B
Manufacturer Part Number
R88A-CAWE020B
Description
POWER CABLE W/BRAKE 20M
Manufacturer
Omron
Datasheet
1.R88A-TK02W.pdf
(479 pages)
Specifications of R88A-CAWE020B
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
R88ACAWE020B
- Current page: 236 of 479
- Download datasheet (5Mb)
System Design and Installation
• Use ground lines with a minimum thickness of 3.5 mm
• If no-fuse breakers are installed at the top and the power supply line is wired from the lower duct, use
• No-fuse breakers, surge absorbers, and noise filters (NF) should be positioned near the input terminal
• If surge absorbers are installed, incorporate a fuse to protect against short-circuit failure. As a guide,
• Wire the noise filter as shown at the left in the following illustration. The noise filter should be installed
• Use twisted-pair cables for the power supply cables whenever possible, or bind the cables.
• Separate power supply cables and signal cables when wiring.
H Selecting Components
3-22
are as short as possible.
metal tubes for wiring and make sure that there is adequate distance between the input lines and the
internal wiring. If input and output lines are wired together, noise resistance will decrease.
block (ground plate), and I/O lines should be isolated and wired using the shortest distance possible.
select a fuse with approximately three times the maximum momentary current.
at the entrance to the control box whenever possible.
This section explains the criteria for selecting the connection components required for
improving noise resistance. These criteria include capacity performance, applicable
range, and so on. For more details, contact the manufacturers directly.
Correct: Properly twisted
Correct:
Driver
or
2
, and arrange the wiring so that the ground lines
WRONG:
Binding
Correct: Cables are bound.
Driver
Chapter 3