NT30C-CFL01 Omron, NT30C-CFL01 Datasheet - Page 270

• Manufacturer Part Number: NT30C-CFL01
• Description: REPL BACKLIGHT FOR NT30C
• Manufacturer: Omron

Specifications of NT30C-CFL01

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: NT30CCFL01

Precautions for
Force-setting,
Force-resetting, and
Clearing Forced Status
2-17-6 Using the Continuous Monitor Screen
Device Monitor Function
Reference: A word or bit address that has been specified will remain valid until the PT is
turned OFF or reset. The settings will remain valid even if the Device Monitor
function is closed, so the last valid settings will be displayed the next time that the
Device Monitor function is started.
When the following operations are performed at the PC or at the PT (with the
Device Monitor), the Device Monitor display may not properly reflect the force-
set status, force-reset status, or cleared forced status.
• A word displayed with bits that have forced status should be displayed again
• A bit that was force-set or force-reset from Device Monitor is cleared from the
• A bit that was force-set from Device Monitor is force-reset from the PC or a bit
• The PC is switched from RUN mode to MONITOR or PROGRAM mode with
Observe the following precautions in addition to the precautions listed above.
• When the PC is in RUN mode, it is not possible to force-set, force-reset, or
• Do not force-set or force-reset the status of bits in write-protected areas or
The continuous monitor screen can be used to display the contents of words in
the DM Area and EM Area.
2. Press the Release or Force release touch switch in popup input window. A
3. Press the Write touch switch to clear the forced status of all bits and timer/
4. Press the Back touch switch to close the popup input window.
operating.)
after exiting the display.
PC (In addition to intentional forced-status clear operations, the same forced-
status clear condition can occur by turning the PC OFF or disconnecting
cables.)
that was force-reset from Device Monitor is force-set from the PC.
the Forced Status Hold Bit set to OFF.
clear the forced status of bits.
areas where the operation normally cannot be performed.
confirmation message will be displayed in the bottom-left corner of the
screen.
counter Completion Flags in the PC.
If the Clear touch switch is pressed instead of Write, the forced-status clear
operation will be cancelled and the PT will revert to the ordinary binary PV
specification screen.
If the Back touch switch is pressed before Write, the forced-status clear op-
eration will not be completed and the PT will restart monitoring with the origi-
nal conditions.
Section
2-17
261