AT42QT1110-AU Atmel, AT42QT1110-AU Datasheet - Page 9

• Manufacturer Part Number: AT42QT1110-AU
• Description: IC TOUCH SENSOR 11KEY 32TQFP
• Manufacturer: Atmel
• Series: QTouch™r
• Type: Capacitiver

Specifications of AT42QT1110-AU

• Touch Panel Interface: 10, 2-Wire
• Number Of Inputs/keys: 11 Key
• Data Interface: Serial, SPI™
• Voltage Reference: Internal
• Voltage - Supply: 3 V ~ 5.5 V
• Current - Supply: 8mA, 12mA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 32-TQFP
• Output Type: Logic
• Interface: SPI
• Input Type: Logic
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: AT42QT1110-AU; AT42QT1110-AUTR

3.5
3.5.1
3.5.2
3.6
9520I–AT42–03/10
Power Supply
MLF Package Restrictions
General Considerations
Brownout Detection
See
with temperature, the device tracks and compensates for these changes automatically with only
minor changes in sensitivity. If the supply voltage drifts or shifts quickly, the drift compensation
mechanism is not able to keep up, causing sensitivity anomalies or false detections.
The usual power supply considerations with QT parts apply to the device. The power should be
clean and come from a separate regulator if possible. However, this device is designed to
minimize the effects of unstable power, and, except in extreme conditions, should not require a
separate Low Dropout (LDO) regulator.
See underneath
It is assumed that a larger bypass capacitor (like1 µF) is somewhere else in the power circuit; for
example, near the regulator.
The QT1110 includes a power supply monitoring circuit that detects if Vdd drops below a safe
operating voltage. When this occurs, the device goes into a “Reset” state, where no acquisition
or processing is carried out. The device remains in this state until Vdd returns to the specified
voltage range.
Once a safe operating voltage is detected, the QT1110 behaves as per normal power-on/reset
conditions; that is, any saved settings are restored from EEPROM, the internal self-tests are run
and all channels are calibrated.
The Brown-out detector threshold is 2.7V ±10 percent.
The central pad on the underside of the MLF chip should be connected to ground. Do not run
any tracks underneath the body of the chip, only ground.
good/bad tracking.
Figure 3-1.
Section 8.2 on page 38
close to the power pins of the IC. Failure to do so can result in device oscillation,
high current consumption, erratic operation etc.
Caution: A regulator IC shared with other logic can result in erratic operation and is
not advised.
A single ceramic 0.1 µF bypass capacitor, with short traces, should be placed very
Example of GOOD Tracking
Examples of Good and Bad Tracking
Figure 1.3 on page 4
for the power supply range. If the power supply fluctuates slowly
AT42QT1110-MU/AT42QT1110-AU
for suggested regulator manufacturers.
Example of BAD Tracking
Figure 3-1
shows an example of
9