QT114A-ISG Atmel, QT114A-ISG Datasheet - Page 45

• Manufacturer Part Number: QT114A-ISG
• Description: IC TOUCH SENSOR PROX 8SOIC
• Manufacturer: Atmel
• Series: QLevel™r
• Type: Liquid or Powderr

Specifications of QT114A-ISG

• Output Configuration: Open Collector: Dry-Low
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Voltage Rating: 2.45 ~ 5.25 V
• Current: 20uA
• Current - Supply: *
• Output Type: *
• Interface: *
• Input Type: *
• Operating Supply Voltage: 2.5 V to 5.25 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SOIC-8
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Package / Case: -
• Lead Free Status / Rohs Status: Details

4.3.4
4.3.5
4.3.6
4.3.7
4.3.8
Touch Sensors Design Guide
Adapting the Planar Construction For Distribution Across Two Layers
Ground Loading
Illumination Effects
Floating Conductive Items
Conductive Paints
For completeness, it is worth noting that the planar construction detailed in
be distributed across two layers if desired; it may, for example, make the layout and interconnections
easier. Generally, try to keep the Y layer nearest to touch and avoid separating the Y and X layers
vertically by more than 10 percent of the X to Y gap.
A non-planar construction method tends to have less potential for signal loss from nearby ground loads,
and so is generally far less sensitive than a planar design. Flooded-X style sensors are particularly good
in this regard because the X drive has a low impedance. This means that it can be loaded with relatively
high amounts of parasitic capacitance before the RC time constant becomes a concern.
Generally, the considerations of
The issues for illumination are very similar to those presented in
page
electrode can be opened to make way for an LED (see
necessary to increase the diameter of the Y electrode slightly while ensuring that the surrounding ring
has the greatest width as possible.
Figure 4-13. Using an LED With a Spring In a Mutual-capacitance Type Sensor
The considerations for the use of floating conductive items described in
Conductive Items” on page 4-9
The considerations for the use of conductive paints described in
page 3-7
3-10. When considering the use of LEDs in the centre of spring-based sensors, the Y disc
apply.
apply.
Section 4.2.3 “Ground Loading” on page 4-6
Y Electrode
Mutual-capacitance Zero-dimensional Sensors
LED
Figure 4-13 on page
Section 3.3.5 “Illumination Effects” on
Section 3.2.7 “Conductive Paints” on
Section 4.2 on page 4-1
4-13). In this case it may be
X Electrode
will apply.
Section 4.2.6 “Floating
10620D–AT42–04/09
4-13
can