ZICM0868P0-KIT1-1 CEL, ZICM0868P0-KIT1-1 Datasheet
ZICM0868P0-KIT1-1
Specifications of ZICM0868P0-KIT1-1
Related parts for ZICM0868P0-KIT1-1
ZICM0868P0-KIT1-1 Summary of contents
Page 1
... Document No: 0009-00-07-00-000 (Issue ES) Date Published: June 10, 2011 PRELIMINARY DATA SHEET MeshConnect™ Sub-G Module Series 868 / 900 MHz System-on-Chip (SoC) Based Modules ZICM0868P0-KIT1-1 and ZICM0900P2-KIT1-1 MeshConnect ZICM0868P0 • Long Range • Low Power Consumption • 868 and 900 MHz Frequency Ranges • ...
Page 2
... ZICM0900P2-1C MeshConnect™ ZICM0900P2-1CU-SN Sub-G Module (902-928 MHz) ZICM0900P2-1CS-SN ZICM0900P2-1C-SN ZICM0868P0-KIT1-1 MeshConnect™ Sub-G Development Kits ZICM0900P2-KIT1-1 MeshConnect™ Sub-G Module Series Description 868 MHz Module, +13dBm SoC with U.FL connector for external antenna 868 MHz Module, +13dBm SoC with RP-SMA connector for external antenna 868 MHz Module, +13dBm SoC with 1/4 wave wire antenna 900 MHz Module, +20dBm SoC with U ...
Page 3
... For more detail information regarding MeshConnect Development Kits, refer to the respective development kit user guides documents. (Available at CEL’s website: www.cel.com/MeshConnect) DEVELOPMENT KIT ORDERING INFORMATION Part Number Order Number ZICM0868P0-KIT1-1 MeshConnect™ Sub-G Development Kits ZICM0900P2-KIT1-1 MeshConnect™ Sub-G Module Series ANT MeshConnect ...
Page 4
TABLE OF CONTENTS Introduction and Overview Description.............................................................................................................................................................................................. Features.................................................................................................................................................................................................. Applications............................................................................................................................................................................................ Ordering Information............................................................................................................................................................................. Module Block Diagram........................................................................................................................................................................... Development Kit..................................................................................................................................................................................... System Level Function Transceiver IC......................................................................................................................................................................................... Antenna................................................................................................................................................................................................... Additional Flash Memory....................................................................................................................................................................... Electrical Specification Absolute Maximum Ratings................................................................................................................................................................... Recommended (Operating Condition).................................................................................................................................................. DC Characteristics.................................................................................................................................................................................. RF Characteristics.................................................................................................................................................................................. Pin Signal & Interfaces Pin Signals I/O Configuration................................................................................................................................................................ I/O Pin Assignment................................................................................................................................................................................. ...
Page 5
... For more information about the Silicon Labs ICs, visit http://www.silabs.com. ANTENNA The MeshConnect Sub-G modules include RF connectors for external antenna options only (There is no trace antenna option). The following options are supported by CEL: • U.FL connector to support cabled antenna • ...
Page 6
... MeshConnect™ Sub-G Module Min Typ Max 1.8/2.7* 3.3 3.5 865 – 870 902 – 928 - 3.5V, ZICM0868P0 TX power max) DD MeshConnect™ Sub-G Module Min Typ Max – 42 – – 24 – – 1.2 – = 3.5V, ZCM0900P2 TX power max) DD MeshConnect™ Sub-G Module ...
Page 7
... General Characteristics RF Frequency Range Transmitter Maximum Output Power Minimum Output Power FSK Error Deviation Receiver Sensitivity (1% PER, 150kbps) Saturation (maximum input level) MeshConnect™ Sub-G Module Series = 3.5V, ZICM0868P0) DD MeshConnect™ Sub-G Module Min Typ Max 865 – 870 – 13 – ...
Page 8
... P0.4/TXD Module's UART TXD 16 WP Write Protect Pin of Memory Chip on Module GND 19 GND P0.3 Used as Chip Select for Memory IC on the CEL Module 24 P0.2 Memory IC MISO signal pin 25 P0.1 Connected to NIRQ 26 P0.0 Memory IC Clock Signal 27 GND 28 VCC 29 RST/C2CK Debug Clock 30 P2.7/C2D Debug Data 31 P2 ...
Page 9
... GND 55 GND 56 GND Note: The CEL Sub G module has internal connections between Castellation Pins 12 & 49 and 25 & allow stand alone operation with both SNAP and CEL firmware images. SOFTWARE/FIRMWARE The Sub-G modules support the following software: • Synapse SNAP Embedded Firmware • ...
Page 10
SOFTWARE/FIRMWARE (Continued) • Self Healing (Orphan handling) • Point-to-Point network formation • Point-to-Multipoint (Star) network formation • Mesh network formation* • ACK • Wakeup Modes (Si100X) • Frequency Hopping • Unicast Addressing using 16-bit device IDs • Broadcast Addressing • ...
Page 11
... EVALUATION BOARD CEL provides an Evaluation board to allow easy testing of the Module. The Evaluation board provides power via: • AA cell batteries • USB • AC Adapter regulated down to 3.3VDC • External Lab Power Supply (A jumper is also provided for the purposes of monitoring the DC current of the module under various modes of operation) ...
Page 12
PROCESSING Recommended Reflow Profile Parameters Values Ramp up rate (from Tsoakmax to Tpeak) Minimum Soak Temperature Maximum Soak Temperature Soak Time TLiquidus Time above TL Tpeak Time within 5º of Tpeak Time from 25º to Tpeak Ramp down rate Pb-Free Solder Paste ...
Page 13
... This device must accept any interference received, including interference that may cause undesired operation. Warning (Part 15.21) Changes or modifications not expressly approved by CEL could void the user's authority to operate the equipment Separation Distance To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter ...
Page 14
... Health Canada limits for the general population. Consult Safety Code 6, obtainable from Health Canada's website: http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/99ehd-dhm237/index-eng.php CE Certification — Europe ZICM0868P0 (PENDING) The MeshConnect 868MHz RF modules will be tested and certified for the European Union. OEM Responsibility to the European Union Compliance Rules If the MeshConnect module incorporated into a product, the OEM must verify compliance of the final product to the European Harmonized EMC and Low-Voltage / Safety Standards ...
Page 15
... CEL conducts 100% RF and DC factory testing on all production parts and also conducts sample testing on all device lots. CEL’s builds the quality into our products giving our customers the confidence when integrating our products into their systems. MeshConnect™ Sub-G Module Series ...
Page 16
... CEL does not assume any liability for infringement of patents, copyrights or other intellectual property rights of third parties by or arising from the use of CEL products listed in this document or any other liability arising from the use of such products. No license, express, implied or otherwise, is granted under any patents, copyrights or other intellectual property rights of CEL or others. • ...