WD30-SE01 Omron, WD30-SE01 Datasheet - Page 164

• Manufacturer Part Number: WD30-SE01
• Description: WIRELESS DNET SLAVE RMT ANT.
• Manufacturer: Omron

Specifications of WD30-SE01

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: WD30SE01

152
10-3 Maintenance
10-3-1 Cleaning
10-3-2 Inspection
Inspection equipment
Required equipment
Maintenance
Error content
Send error
Communication
error
Verify error
!Caution Never use volatile solvents such as paint thinner or benzene or chemical
Bit address
05
06
07
This section describes the routine cleaning and inspection and the equipment
handling procedure for replacement.
Clean the network regularly as described below in order to keep it in its opti-
mal operating condition.
wipes. These substances could damage the surface of the Unit.
Be sure to inspect the system periodically to keep it in its optimal operating
condition. In general, inspect the system once every 6 to 12 months, but
inspect more frequently if the system is used at high temperatures or humidity
or under dirty/dusty conditions.
Prepare the following equipment before inspecting the system.
• Wipe the Unit with a dry, soft cloth for regular cleaning.
• When a spot cannot be removed with a dry cloth, dampen the cloth with a
• A smudge may remain on the Unit from gum, vinyl, or tape that was left on
• Standard and Phillips screwdrivers
• Multimeter (or digital volt meter)
Cause
Network power supply
error, send timeout
Remote I/O communica-
tion timeout
Discrepancy slave I/O size,
no slave
neutral cleaner (diluted to 2%), wring out the cloth, and wipe the Unit.
for a long time. Remove the smudge when cleaning.
Check the network power supply and the
network cable wiring.
Review the following items.
• Communication speed
• Cable length (main/branch)
• Broken or loose cable
• Terminating
• Excessive noise
Review the following items
• Communication speed
• Cable length (main/branch)
• Broken or loose cable
• Terminating
• Excessive noise
After checking the slave, initialize the unit
and re-entry the slave again.
• Communication speed
• Cable length (main/branch)
• Broken or loose cable
• Terminating
• Excessive noise
Remedy
installed on both ends of the main line.
installed on both ends of the main line.
installed on both ends of the main line.
resistor
resistor
resistor
should
should
should
Section 10-3
only
only
only
be
be
be