M27W016-100M1 STMicroelectronics, M27W016-100M1 Datasheet - Page 7
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
M27W016-100M1
Manufacturer Part Number
M27W016-100M1
Description
Manufacturer
STMicroelectronics
Datasheet
1.M27W016-100M1.pdf
(26 pages)
Specifications of M27W016-100M1
Interface Type
Parallel
In System Programmable
External
Access Time (max)
100ns
Package Type
SO
Reprogramming Technique
OTP
Operating Supply Voltage (typ)
3.3V
Operating Supply Voltage (min)
2.7V
Operating Supply Voltage (max)
3.6V
Supply Current
10mA
Pin Count
44
Mounting
Surface Mount
Operating Temp Range
0C to 70C
Operating Temperature Classification
Commercial
Lead Free Status / Rohs Status
Supplier Unconfirmed
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
SIGNAL DESCRIPTIONS
See Figure 2, Logic Diagram, and Table 1, Signal
Names, for a brief overview of the signals connect-
ed to this device.
Address Inputs (A0-A19). The Address Inputs
select the cells in the memory array to access dur-
ing Bus Read operations. During Bus Write opera-
tions they control the commands sent to the
Command Interface of the Program Controller.
Data Inputs/Outputs (DQ0-DQ7). The Data In-
puts/Outputs output the data stored at the selected
address during a Bus Read operation. During Bus
Write operations they represent the command
sent to the Command Interface of the Program
Controller. When reading the Status Register they
report the status of the ongoing algorithm.
Data Inputs/Outputs (DQ8-DQ15). The Data In-
puts/Outputs output the data stored at the selected
address during a Bus Read operation. During Bus
Write operations the Command Interface does not
use these bits. When reading the Status Register
these bits should be ignored.
Chip Enable (E). The Chip Enable, E, activates
the memory, allowing Bus Read operations to be
performed. It also controls the Bus Write opera-
tions, when V
Output Enable (G). The Output Enable, G, con-
trols the Bus Read operations of the memory. It
PP
is in the V
HH
range.
also allows Bus Write operations, when V
the V
V
supplies the power for Read operations.
A 0.1µF capacitor should be connected between
the V
pin to decouple the current surges from the power
supply. The PCB track widths must be sufficient to
carry the currents required during program opera-
tions, I
V
power supply and Write Protect pin. The two func-
tions are selected by the voltage range applied to
the pin.
When the V
DC Characteristic, for the relevant values) the Pro-
gram operation is enabled. During such opera-
tions the V
If the V
in the voltage range 0 to 3.6V, any Program oper-
ation is disabled or stopped.
Note that V
nected as the device may become unreliable.
Vss Ground. The V
for all voltage measurements.
CC
PP
Supply Voltage. The V
Program Supply Voltage. V
HH
CC
CC3
PP
range.
Supply Voltage pin and the V
is kept under the V
.
PP
PP
PP
must be stable in the V
must not be left floating or uncon-
is in the V
SS
Ground is the reference
HH
range (see Table 10,
HH
CC
range, particularly
Supply Voltage
PP
HH
M27W016
SS
is both a
range.
Ground
PP
is in
7/26