MAX4753EGE+T Maxim Integrated Products, MAX4753EGE+T Datasheet - Page 9
![IC SWITCH QUAD SPST 16QFN](/photos/6/66/66625/16-tqfn_exp_pad_21-0136_sml.jpg)
MAX4753EGE+T
Manufacturer Part Number
MAX4753EGE+T
Description
IC SWITCH QUAD SPST 16QFN
Manufacturer
Maxim Integrated Products
Datasheet
1.MAX4753EGE.pdf
(13 pages)
Specifications of MAX4753EGE+T
Function
Switch
Circuit
4 x SPST - NC/NO
On-state Resistance
900 mOhm
Voltage Supply Source
Single Supply
Voltage - Supply, Single/dual (±)
1.6 V ~ 3.6 V
Current - Supply
1µA
Operating Temperature
-40°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
16-TQFN Exposed Pad
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
The MAX4751/MAX4752/MAX4753 are low 0.9Ω max (at
V+ = 3V) on-resistance, low-voltage quad analog
switches that operate from a +1.6V to +3.6V single sup-
ply. CMOS construction allows switching analog signals
that are within the supply voltage range (GND to V+).
When powered from a +3V supply, the 0.9Ω (max) R
allows high continuous currents to be switched in a
variety of applications.
Proper power-supply sequencing is recommended for
all CMOS devices. Do not exceed the absolute maxi-
mum ratings because stresses beyond the listed rat-
ings can cause permanent damage to the devices.
Always sequence V+ on first, followed by NO_, NC_, or
COM_. If power-supply sequencing is not possible, add
two small-signal diodes (D1, D2) in series with the sup-
ply pins for overvoltage protection (Figure 5). Adding
these diodes reduces the analog signal by one diode
drop below V+ and one diode drop above GND, but
does not affect the low switch resistance and low leak-
age characteristics of the device. Device operation is
unchanged, and the difference between V+ and GND
should not exceed 4V.
Power-supply bypassing is needed to improve noise
margin and to prevent switching noise propagation
from the V+ supply to other components. A 0.1µF
capacitor, connected from V+ to GND, is adequate for
most applications.
The MAX4751/MAX4752/MAX4753 logic inputs can be
driven up to +3.6V regardless of the supply voltage. For
example, with a +1.8V supply, IN_ may be driven low to
GND and high to +3.6V. Driving IN_ rail-to-rail mini-
mizes power consumption.
Analog signals that range over the entire supply voltage
(V+ to GND) can be passed with very little change in on-
0.9Ω, Low-Voltage, Single-Supply Quad SPST
Applications Information
_______________________________________________________________________________________
Detailed Description
Analog Signal Levels
Logic Inputs
ON
resistance (see the Typical Operating Characteristics).
The switches are bidirectional, so the NO_, NC_, and
COM_ pins can be used as either inputs or outputs.
High-speed switches require proper layout and design
procedures for optimum performance. Reduce stray
inductance and capacitance by keeping traces short
and wide. Ensure that bypass capacitors are as close
to the device as possible. Use large ground planes
where possible.
TRANSISTOR COUNT: 228
PROCESS: CMOS
Figure 5. Overvoltage Protection Using Two External Blocking
Diodes
V g
Analog Switches
COM
POSITIVE SUPPLY
V+
GND
D2
D1
Chip Information
NO
MAX4751
MAX4752
MAX4753
Layout
9