C500-NC222-E Omron, C500-NC222-E Datasheet - Page 56

• Manufacturer Part Number: C500-NC222-E
• Description: 27C0061
• Manufacturer: Omron

Specifications of C500-NC222-E

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Rohs Compliant: No

2. Turning the Servo ON
3. Setting the Voltage of Speed Command Input to 0 V
4. Setting the Direction that Provides Offset
5. Adjusting Offset
6. Closing the Speed Command Manual Zero Adjustment Window
Speed Command Manual Zero Adjustment window opens.




Input the Run signal (ON). When bit No. 0 of setup parameter No. 1 is set to “1,” this operation is not
required.
Type voltage of speed command input (REF) with which the number of rotations becomes zero
(normally 0 V).
Select [Up] (providing offset on positive side) or [Down] (providing offset on negative side).
Adjust the offset so that motor or machine stops completely.
Move the mouse cursor over [Up] or [Down].
Select [Up] or [Down] using the Tab Key.
Click on [Up] or [Down]. The offset value increases or decreases by 1 for every click.
Press the Space Key. The offset value increases or decreases by 1 each time the Space Key is
pressed.
Click on [ ] in the upper-left part of the window.
Press the Escape Key.
Chapter 5