184196-1 TE Connectivity, 184196-1 Datasheet - Page 4

• Manufacturer Part Number: 184196-1
• Description: Power to the Board HSG CAP 1X03C LOCK PLATE
• Manufacturer: TE Connectivity

Specifications of 184196-1

• Product Type: Accessories
• Number Of Positions / Contacts: 3
• Accessory Type: Cap Lock Plate
• Product Line: Sealed Sensor Connector (SSC)
• Accessory Color: Yellow
• Number Of Positions: 3
• Number Of Rows: 1
• Rohs/elv Compliance: ELV compliant
• Lead Free Solder Processes: Not reviewed for lead free solder process
• Rohs/elv Compliance History: Always was ELV compliant
• Application Use: Wire-to-Wire / Wire-to-Panel
• Packaging Method: Box
• Packaging Quantity: 3000
• Lead Free Status / Rohs Status: Details
• For Use With: Cap Housing

Rev B
High temperature exposure.
Humidity-temperature cycling.
Immersion.
Pressure/vacuum leak.
NOTE
Test Description
Shall meet visual requirements, show no physical damage, and meet requirements of additional
tests as specified in the Product Qualification and Requalification Test Sequence shown in Figure
2.
See Note.
See Note.
No evidence of leakage.
See Note.
No evidence of leakage.
See Note.
Figure 1 (end)
Requirement
USCAR 5.6.3. (Rev 4/01)
Subject mated specimens to
temperature life at 125° C for PBT
housings and 150° C for nylon
housings for 1008 hours.
USCAR 5.6.2. (Rev 4/01)
Subject mated specimens to 15
specified cycles.
See Figure 8.
USCAR 5.3.15. (Rev 8/97)
Subject mated specimens to the
following procedure:
1. Temperature soak specimens for
2 hours at 125° C for PBT housings
and 150° C for nylon housings.
2. Remove specimens from oven
and immediately immerse in 25° C
5% salt solution for 2 hours.
Measure dry circuit resistance.
3. Repeat procedure 4 more times.
USCAR 5.3.16. (Rev 8/97)
Subject mated specimens to the
following procedure:
1. Immerse specimens in 25° C 5%
salt solution and slowly pressurize
to 48 kpa while observing for air
bubbles.
2. Remove pressure and slowly
apply 48 kpa of vacuum.
3. Unmate specimens and examine
for leakage.
4. Temperature soak specimens for
72 hours at 125° C for PBT
housings and 150° C for nylon
housings.
5. Remove specimens and repeat
steps 1 and 2 using 28 kpa.
Procedure
108-1790
4 of 9