ATV12H037M3 Crouzet USA, ATV12H037M3 Datasheet - Page 24

• Manufacturer Part Number: ATV12H037M3
• Description: 11R1086
• Manufacturer: Crouzet USA

Specifications of ATV12H037M3

• No. Of Phases: Three
• Power Rating: 0.37kW
• Output Voltage Max: 230V
• Frequency Range: 0.5 To 400Hz
• Output Current: 2.4A
• Supply Voltage Max: 230V
• Rohs Compliant: Yes

10
1
2
3
4
5
6
7
8
9
Connections
Q1
Note: Install interference suppressors on all inductive circuits near the drive or connected on the same circuit, such as relays, contactors, solenoid valves,
fluorescent lighting, etc.
A1
A2
KM1
P1
Q1
LI1: Forward
LIp: Reverse
24 V ⎓
supply
(1)
(2)
(3)
(4)
(5)
Introduction:
page 8
Recommended connections
Typical connection for ATV12ppppF1, ATV12ppppM2
Compatible components (for a complete list of references, please refer to the "Motor starter solutions - Control and protection components" and "Motor starters
up to 150 A" catalogs or visit "www.schneider-electric.us")
Item no.
Examples of recommended connections for logic and analog I/O
2-wire control
Examples of recommended connections for logic I/O powered by an external 24 V ⎓ supply (5)
Connected as positive logic (Source)
Single-phase power supply
22
KM1
A1
The control section is connected in exactly the same way as for the ATV12ppppF1 and ATV12ppppM2 drives.
Connection as positive logic (Source) or negative logic (Sink) is configured via parameters; the factory-set configuration is positive logic (Source).
Fault relay contacts for remote signalling of the drive status.
The R/L1, S/L2/N and T/L3 terminals are connected at the top of the drive. The other terminals are connected on the underside of the drive.
Please refer to the "Phaseo power supplies and transformers" catalog.
ATV12pppppp
3
Q1
M
Description
ATV12ppppF1 or ATV12ppppM2 drive (see page 14)
ATV12ppppM3 drive (see page 14)
Contactor (only if a control circuit is needed; see page 24)
2.2 kW reference potentiometer, SZ1 RV1202. This can be replaced by a 10 kW potentiometer (maximum).
Circuit breaker (see page 24)
LI1: Stop
LI2: Forward
LIp: Reverse
Specifications:
page 10
3-wire control
ATV12pppppp
Negative logic (Sink) (2)
Positive logic (Source) (2)
c b
P1
a
Altivar
variable speed drives
Drives
24 V ⎓
supply
References:
page 14
+
Analog input configured
for voltage
Connected as negative logic (Sink)
10 V
External 10 V
2.2 kW to 10 kW
reference
potentiometer
c b
ATV12pppppp
a
®
0 to 10 V
or
0-20 mA
12
Q1
Dimensions:
page 18
Analog input configured for current
Typical connection for ATV12ppppM3
Three-phase power supply (power section) (1)
0-20 mA
4-20 mA
supply
KM1
(4)
A2
ATV12pppppp
3
M
Q1
Functions:
page 26