MAX1487 Maxim Integrated Products, MAX1487 Datasheet
MAX1487
Available stocks
Related parts for MAX1487
MAX1487 Summary of contents
Page 1
... The driver slew rates of the MAX481, MAX485, MAX490, MAX491, and MAX1487 are not limited, allowing them to transmit up to 2.5Mbps. These transceivers draw between 120µA and 500µA of supply current when unloaded or fully loaded with disabled drivers ...
Page 2
... CERDIP (derate 9.09mW/°C above +70°C).......727mW Operating Temperature Ranges +0.5V) MAX4_ _C_ _/MAX1487C_ A ...............................0°C to +70°C CC MAX4_ _E_ _/MAX1487E_ A .............................-40°C to +85°C MAX4_ _MJ_/MAX1487MJA ...........................-55°C to +125°C Storage Temperature Range .............................-65°C to +160°C Lead Temperature (soldering, 10sec) .............................+300°C CONDITIONS ...
Page 3
... Supply Current in Shutdown I SHDN Driver Short-Circuit Current, I OSD1 V = High O Driver Short-Circuit Current, I OSD2 V = Low O Receiver Short-Circuit Current I OSR SWITCHING CHARACTERISTICS—MAX481/MAX485, MAX490/MAX491, MAX1487 ( ±5 unless otherwise noted.) (Notes MIN MAX PARAMETER SYMBOL t PLH Driver Input to Output t PHL Driver Output Skew to Output ...
Page 4
... Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers SWITCHING CHARACTERISTICS—MAX481/MAX485, MAX490/MAX491, MAX1487 (continued ±5 unless otherwise noted.) (Notes MIN MAX PARAMETER SYMBOL Driver Enable from Shutdown to t ZH(SHDN) Output High (MAX481) Driver Enable from Shutdown to t ZL(SHDN) Output Low (MAX481) Receiver Enable from Shutdown ...
Page 5
NOTES FOR ELECTRICAL/SWITCHING CHARACTERISTICS Note 1: All currents into device pins are positive; all currents out of device pins are negative. All voltages are referenced to device ground unless otherwise specified. Note 2: All typical specifications are given for V ...
Page 6
... OUTPUT CURRENT vs. DRIVER OUTPUT HIGH VOLTAGE -120 -100 -80 -60 -40 - OUTPUT HIGH VOLTAGE (V) SUPPLY CURRENT vs. TEMPERATURE 600 500 400 , MAX1487 300 , 200 MAX1487 0V 100 CC 0 -60 - 100 125 MAX481/MAX485/MAX490/MAX491 SUPPLY CURRENT vs. TEMPERATURE 600 MAX481/MAX485 500 400 300 MAX485 MAX481 200 MAX490/MAX491 100 MAX481 -50 - ...
Page 7
... MAX481 7 GND MAX483 MAX485 MAX487 MAX1487 MAX Figure 1. MAX481/MAX483/MAX485/MAX487/MAX1487 Pin Configuration and Typical Operating Circuit _______________________________________________________________________________________ Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers NAME MAX489/ NAME MAX491 DIP/SO Receiver Output > 200mV, RO will be high < 200mV, RO will be low. Receiver Output Enable enabled when RE is low high impedance when RE is high. ...
Page 8
... RS-485 drivers (32 trans- ceivers maximum). Any combination of MAX487/ MAX1487 and other RS-485 transceivers with a total of 32 unit loads or less can be put on the bus. The MAX481/MAX483/MAX485 and MAX488–MAX491 have standard 12k Receiver Input impedance. ...
Page 9
... The MAX483 and MAX487–MAX489 are slew-rate limit- ed, minimizing EMI and reducing reflections caused by improperly terminated cables. Figure 12 shows the dri- ver output waveform and its Fourier analysis of a 150kHz signal transmitted by a MAX481, MAX485, MAX490, MAX491, or MAX1487. High-frequency har- _______________________________________________________________________________________ Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers RECEIVER ...
Page 10
... DIFF 90 SKEW = PLH PHL Figure 8. Driver Propagation Delays 1.5V V OUTPUT PHL PLH INPUT ID Figure 10. Receiver Propagation Delays _________________Function Tables (MAX481/MAX483/MAX485/MAX487/MAX1487) Table 1. Transmitting INPUTS High High Don't care High-Z = High impedance * Shutdown mode for MAX481/MAX483/MAX487 10 ______________________________________________________________________________________ 3V DE 1.5V 1.5V 0V 1/2 V ...
Page 11
... MAX483 and MAX487–MAX489. The driver skew times are typically 5ns (10ns max) for the MAX481, MAX485, MAX490, MAX491, and – — – MAX1487, and are typically 100ns (800ns max) for the MAX483 and MAX487–MAX489. 5MHz 500kHz/div Driver Output Protection Propagation Delay - PLH ...
Page 12
... Figure 15. MAX481/MAX485/MAX490/MAX491/MAX1487 Receiver t PHL A 500mV/div B RO 2V/div 400ns/div Figure 17. MAX483, MAX487–MAX489 Receiver t 12 ______________________________________________________________________________________ 100pF Z B TTL < 6ns 100pF 500mV/div A 2V/div RO Figure 16. MAX481/MAX485/MAX490/MAX491/MAX1487 Receiver t PLH B 500mV/div + 2V/div RO Figure 18. MAX483, MAX487–MAX489 Receiver t PHL RECEIVER OUT + 20ns/div + 400ns/div PLH ...
Page 13
... Figures 19 and 20 show the system differential voltage for the parts driving 4000 feet of 26AWG twisted-pair wire at 110kHz into 120 loads. Typical Applications The MAX481, MAX483, MAX485, MAX487–MAX491, and MAX1487 transceivers are designed for bidirectional data communications on multipoint bus transmission lines ...
Page 14
Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers A 120 120 NOTE: RE AND DE ON MAX489/MAX491 ONLY. Figure 22. MAX488–MAX491 Full-Duplex RS-485 Network MAX488–MAX491 A RO 120 ...
Page 15
... Plastic DIP MAX491ESD 8 SO MAX491MJD 8 µMAX MAX1487CPA Dice* MAX1487CSA 8 Plastic DIP MAX1487CUA 8 SO MAX1487C/D 8 CERDIP MAX1487EPA 8 Plastic DIP MAX1487ESA 8 SO MAX1487MJA 8 µMAX Dice* * Contact factory for dice specifications. 8 Plastic DIP CERDIP _________________Chip Topographies 8 Plastic DIP 8 SO MAX481/MAX483/MAX485/MAX487/MAX1487 8 µMAX Dice* 8 Plastic DIP ...
Page 16
Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers _____________________________________________Chip Topographies (continued) MAX488/MAX490 N.C. N.C. DI GND 0.080" (2.032mm) 16 ______________________________________________________________________________________ 0.054" Z (1.372mm TRANSISTOR COUNT: 248 SUBSTRATE CONNECTED TO GND MAX489/MAX491 ...
Page 17
For the latest package outline information go to www.maxim-ic.com/packages.) ______________________________________________________________________________________ Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers Package Information 17 ...
Page 18
Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) 18 ______________________________________________________________________________________ Package Information (continued) ...
Page 19
... Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 ____________________ 19 © 2003 Maxim Integrated Products ...