TDA8563Q/N2,112 NXP Semiconductors, TDA8563Q/N2,112 Datasheet - Page 16

• Manufacturer Part Number: TDA8563Q/N2,112
• Description: IC AMP AUDIO PWR 55W STER 13SIL
• Manufacturer: NXP Semiconductors
• Type: Class Br

Specifications of TDA8563Q/N2,112

• Output Type: 2-Channel (Stereo)
• Max Output Power X Channels @ Load: 55W x 2 @ 2 Ohm
• Voltage - Supply: 6 V ~ 18 V
• Features: Depop, Mute, Short-Circuit and Thermal Protection, Standby
• Mounting Type: Through Hole
• Package / Case: 13-SIL (Bent and Staggered Leads)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-3483-5; 935258490112; TDA8563QU

Philips Semiconductors
SOLDERING
Introduction to soldering through-hole mount
packages
This text gives a brief insight to wave, dip and manual
soldering. A more in-depth account of soldering ICs can be
found in our “Data Handbook IC26; Integrated Circuit
Packages” (document order number 9398 652 90011).
Wave soldering is the preferred method for mounting of
through-hole mount IC packages on a printed-circuit
board.
Soldering by dipping or by solder wave
The maximum permissible temperature of the solder is
260 C; solder at this temperature must not be in contact
with the joints for more than 5 seconds.
The total contact time of successive solder waves must not
exceed 5 seconds.
Suitability of through-hole mount IC packages for dipping and wave soldering methods
Note
1. For SDIP packages, the longitudinal axis must be parallel to the transport direction of the printed-circuit board.
2001 Feb 21
DBS, DIP, HDIP, SDIP, SIL
2
amplifier with diagnostic facility
40 W/2
PACKAGE
stereo BTL car radio power
suitable
DIPPING
16
The device may be mounted up to the seating plane, but
the temperature of the plastic body must not exceed the
specified maximum storage temperature (T
printed-circuit board has been pre-heated, forced cooling
may be necessary immediately after soldering to keep the
temperature within the permissible limit.
Manual soldering
Apply the soldering iron (24 V or less) to the lead(s) of the
package, either below the seating plane or not more than
2 mm above it. If the temperature of the soldering iron bit
is less than 300 C it may remain in contact for up to
10 seconds. If the bit temperature is between
300 and 400 C, contact may be up to 5 seconds.
SOLDERING METHOD
suitable
(1)
WAVE
Product specification
TDA8563Q
stg(max)
). If the