MAX9752CETI+ Maxim Integrated Products, MAX9752CETI+ Datasheet - Page 23
![no-image](/images/manufacturer_photos/0/4/417/maxim_integrated_products_sml.jpg)
MAX9752CETI+
Manufacturer Part Number
MAX9752CETI+
Description
IC AMP AUDIO PWR 1.7W D 28TQFN
Manufacturer
Maxim Integrated Products
Series
DirectDrive™r
Type
Class Dr
Datasheet
1.MAX9753ETI.pdf
(29 pages)
Specifications of MAX9752CETI+
Output Type
2-Channel (Stereo) with Stereo Headphones
Max Output Power X Channels @ Load
1.7W x 2 @ 4 Ohm; 62mW x 2 @ 16 Ohm
Voltage - Supply
4.5 V ~ 5.5 V
Features
Depop, Short-Circuit and Thermal Protection, Shutdown, Volume Control
Mounting Type
Surface Mount
Package / Case
28-TQFN Exposed Pad
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Connect all components associated with the charge
pump (C2 and C3) to CPGND. Connect V
together at C2. Place the charge-pump capacitors (C1,
C2, and C3) as close to the device as possible. Bypass
HPV
capacitor and a 100µF capacitor to PGND. Place the
bypass capacitors as close to the device as possible.
Use large, low-resistance output traces. Current drawn
from the outputs increases as load impedance
decreases. High-output-trace resistance decreases the
power delivered to the load. For example, when com-
pared to a 0Ω trace, a 100mΩ trace reduces the power
delivered to a 4Ω load from 2.1W to 2.0W. Large out-
put, supply, and GND traces allow more heat to move
from the MAX9752/MAX9753/MAX9754 to the air,
reducing the thermal impedance of the system.
The MAX9752/MAX9753/MAX9754 thin QFN packages
feature exposed pads on their undersides. Connect the
exposed pad to GND with a large copper pad and mul-
tiple vias to the ground plane.
Filterless Class D amplifiers use the loudspeaker’s coil
inductance to filter out switching energy. Additionally, the
loudspeaker does not respond to the switching frequen-
cy of Class D amplifiers, nor could human ears hear
these frequencies. However, audio analyzers and oscil-
loscopes can detect these signals. On an oscilloscope,
2.2W, Low-EMI, Stereo, Class D Power Amplifiers
DD
with 1µF to GND. Bypass PV
______________________________________________________________________________________
Measuring Class D Outputs
with an Analog Analyzer
with DirectDrive Headphone Amplifiers
DD
SS
with a 0.1µF
and CPV
SS
the switching components obscure the audio signal. On
an audio analyzer they overload the input signal, degrad-
ing the measurement from the true audio performance of
the amplifier. A simple RC filter can be used (Figure 13)
to aid in evaluation of Class D amplifiers in the lab. This
circuit provides a single-pole response at 34kHz, with a
minimal insertion loss. More complex designs such as L-
C filters can provide more performance, but must be veri-
fied to ensure they do not add their own distortion
signature to the amplifier’s output.
Figure 13. Connecting a Class D Output to an Analog Analyzer
AND H-BRIDGE
MODULATOR
CLASS D
OUT_+
OUT_-
R
L
100Ω
100Ω
47nF
47nF
IN+
IN-
ANALYZER
AUDIO
23