LM311N/NOPB National Semiconductor, LM311N/NOPB Datasheet - Page 11

• Manufacturer Part Number: LM311N/NOPB
• Description: IC VOLTAGE COMPARATOR 8-DIP
• Manufacturer: National Semiconductor
• Type: General Purposer

Specifications of LM311N/NOPB

• Number Of Elements: 1
• Output Type: DTL, MOS, Open-Collector, Open-Emitter, RTL, TTL
• Voltage - Supply: 5 V ~ 30 V, ±2.5 V ~ 15 V
• Mounting Type: Through Hole
• Package / Case: 8-DIP (0.300", 7.62mm)
• Amplifier Type: Comparator
• Current, Input Bias: 100 nA
• Current, Input Offset: 6 nA
• Current, Output: 50 mA
• Current, Supply: -4.1 to +5.1 mA
• Package Type: DIP-8
• Power Dissipation: 500 mW
• Temperature, Operating, Range: 0 to +70 °C
• Voltage, Gain: 200 V/mV
• Voltage, Input: ±15 V
• Voltage, Input Offset: 2 mV
• Voltage, Supply: 5 to 36 V
• Comparator Type: General Purpose
• No. Of Comparators: 1
• Response Time: 200ns
• Ic Output Type: DTL, MOS, RTL, TTL
• Supply Current: 5.1mA
• Supply Voltage Range: 5V To 36V
• Amplifier Case Style: DIP
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: *LM311N; *LM311N/NOPB; LM311; LM311NNS

8.0 Application Hints
7. When both inputs of the LM111 are connected to active
Pin connections shown are for LM111H in the H08 hermetic package
Pin connections shown are for LM111H in the H08 hermetic package
signals, or if a high-impedance signal is driving the
positive input of the LM111 so that positive feedback
would be disruptive, the circuit of Figure 1 is ideal. The
positive feedback is to pin 5 (one of the offset adjust-
ment pins). It is sufficient to cause 1 to 2 mV hysteresis
and sharp transitions with input triangle waves from a
few Hz to hundreds of kHz. The positive-feedback signal
across the 82Ω resistor swings 240 mV below the posi-
(Continued)
FIGURE 2. Conventional Positive Feedback
FIGURE 1. Improved Positive Feedback
11
8. These application notes apply specifically to the LM111,
tive supply. This signal is centered around the nominal
voltage at pin 5, so this feedback does not add to the
V
trimmed out, using the 5 kΩ pot and 3 kΩ resistor as
shown.
LM211, LM311, and LF111 families of comparators, and
are applicable to all high-speed comparators in general,
(with the exception that not all comparators have trim
pins).
OS
of the comparator. As much as 8 mV of V
00570430
00570429
www.national.com
OS
can be