AP393SG-13 Diodes Inc, AP393SG-13 Datasheet - Page 10

• Manufacturer Part Number: AP393SG-13
• Description: IC COMP DUAL LOW POWER 8-SOIC
• Manufacturer: Diodes Inc
• Type: General Purposer

Specifications of AP393SG-13

• Number Of Elements: 2
• Output Type: CMOS, DTL, ECL, MOS, Open-Collector, TTL
• Voltage - Supply: 2 V ~ 36 V, ±1 V ~ 18 V
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (0.154", 3.90mm Width)
• Output Voltage: 2 V to 36 V
• Output Current: 16 mA
• Input Voltage: 0.3 V to 36 V
• Operating Temperature Range: 0 C to + 70 C
• Mounting Style: SMD/SMT
• Number Of Outputs: 2
• Comparator Type: Low Power
• No. Of Comparators: 2
• Response Time: 1.3µs
• Ic Output Type: CMOS, MOS, TTL, DTL, ECL
• Output Compatibility: CMOS, MOS, DTL, ECL, TTL
• Supply Current: 1mA
• Supply Voltage Range: ± 1V To ± 18V
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: AP393SG-13; AP393SGTR

Electrical Characteristics
(V
Notes:
AP393
Document number: DS31006 Rev. 8 - 2
Symbol
V
CC
I
I
OFFSET
O(Leak)
OFFSET
V
I
BIAS
= 5V) (Note 5)
SAT
10. At output switch point, V
2. For operating at high temperatures, the AP393 must be derated based on a 125°C maximum junction temperature and a
9. Positive excursions of input voltage may exceed the power supply level. As long as the other voltage remains within the
3. Short circuits from the output to V
4. This input current will only exist when the voltage at any of the input leads is driven negative. It is due to the collector-base
5. The AP393 temperature specifications are limited to 0°C < T
6. The direction of the input current is out of the IC due to the PNP input stage. This current is essentially constant, independent of
7. The input common-mode voltage or either input signal voltage should not be allowed to go negative by more than 0.3V. The
8. The response time specified is for a 100mV input step with 5mV overdrive. For larger overdrive signals 300ns can be obtained,
thermal resistance of 170°C/W which applies for the device soldered in a printed circuit board, operating in a still air
ambient.The low bias dissipation and the “ON-OFF” characteristic of the outputs keeps the chip dissipation very small.
(P
ground, the maximum output current is approximately 20mA independent of the magnitude of V
diode action, there is also lateral NPN parasitic transistor action on the IC chip. This transistor action can cause the output
voltages of the comparators to go to the V
is driven negative. This is not destructive and normal output states will re-establish when the input voltage, which is negative,
again returns to a value greater than -0.3V.
junction of the input PNP transistors becoming forward biased and thereby acting as input diode clamps. In addition to this
the state of the output so no loading change exists on the reference or input lines.
upper end of the common-mode voltage range is V
independent of the magnitude of V
see typical performance characteristics section.
common-mode range, the comparator will provide a proper output state. The low input voltage state must not be less than -0.3V
(or 0.3V below the magnitude of the negative power supply, if used).
at 25°C.
Input Offset Voltage
Input Offset Current
Input Bias Current
Input Common Mode Voltage
Range
Saturation Voltage
Output Leakage Current
Differential Input Voltage
D
<100mW), provided the output transistors are allowed to saturate
Parameter
O
~ 1.4V, R
(Continued)
+
can cause excessive heating and eventual destruction. When considering short circuits to
+
.
S
=0Ω with V
+
(Note 10)
I
I
Linear Range, V
(Note 6)
V
V
I
V
V
Keep All V
Used), (Note 9)
IN
IN
SINK
voltage level (or to ground for a large overdrive) for the time duration that an input
+
IN
IN
O
(+) -I
(+) or I
=30V (Note 7)
(-) = 1V, V
(-) = 0, V
= 30V
+
www.diodes.com
< 4mA
from 5V to 30V; and over the full input common-mode range (0V to V
IN
+
-1.5V at 25°C, but either or both inputs can go to 36V without damage,
(-), V
IN
10 of 15
LOW POWER LOW OFFSET VOLTAGE DUAL
Conditions
(-) with Output In
IN
IN
’s > 0V (or V
IN
(+) = 1V,
CM
OP
(+) = 0,
= 0V
< +70°C.
CM
= 0V
-
, if
Min
0
-
-
-
-
-
-
+
.
Typ.
-
-
-
-
-
-
-
COMPARATORS
V
Max
150
400
700
+
1.0
36
9
-2.0
© Diodes Incorporated
AP393
July 2010
Unit
+
mV
mV
nA
nA
μA
-1.5V),
V
V