ADA4430-1YKSZ-R7 Analog Devices Inc, ADA4430-1YKSZ-R7 Datasheet - Page 16
![IC FILTER VIDEO ULTRA LP SC70-6](/photos/6/60/66035/505-sc70-6_sml.jpg)
ADA4430-1YKSZ-R7
Manufacturer Part Number
ADA4430-1YKSZ-R7
Description
IC FILTER VIDEO ULTRA LP SC70-6
Manufacturer
Analog Devices Inc
Type
Video Filterr
Datasheet
1.ADA4430-1YKSZ-RL.pdf
(20 pages)
Specifications of ADA4430-1YKSZ-R7
Design Resources
Reconstruction Video Filter Using ADA4430-1 Amplifier After ADV7393 Video Encoder (CN0101)
Applications
DVD, Game Consoles, Media Players
Mounting Type
Surface Mount
Package / Case
SC-70-6, SC-88, SOT-363
Ic Filter Type
Lowpass
Video Signal Filter
SD
Frequency
27MHz
Bandwidth
9.5MHz
Attenuation
50dB
Filter Order
6th
Variable Gain
X2
Supply Voltage Range
2.5V To 6V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Other names
ADA4430-1YKSZ-R7TR
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ADA4430-1YKSZ-R7
Manufacturer:
ADI/亚德诺
Quantity:
20 000
ADA4430-1
PRINTED CIRCUIT BOARD LAYOUT
As with all high speed applications, attention to printed circuit
board layout is of paramount importance. Standard high speed
layout practices should be adhered to when designing with the
ADA4430-1. A solid ground plane is recommended, and a 0.1 μF
surface-mount, ceramic power supply, decoupling capacitor should
be placed as close as possible to the supply pin.
The GND pin should be connected to the ground plane with a
trace that is as short as possible. Controlled impedance traces of
the shortest length possible should be used to connect to the signal
I/O pins and should not pass over any voids in the ground plane. A
75 Ω impedance level is typically used in video applications. All
signal outputs of the ADA4430-1 should include series termination
resistors when driving transmission lines.
Rev. C | Page 16 of 20
When the ADA4430-1 receives its inputs from a device with
current outputs, the required load resistor value for the output
current is most often different from the characteristic impedance of
the signal traces. In this case, if the interconnections are sufficiently
short (less than 2 inches), the trace does not have to be
terminated in its characteristic impedance.