MAX4275 Maxim, MAX4275 Datasheet - Page 12
![no-image](/images/no-image-200.jpg)
MAX4275
Manufacturer Part Number
MAX4275
Description
The MAX4174/MAX4175/MAX4274/MAX4275 GainAmp family combines a low-cost rail-to-rail op amp with precision internal gain-setting resistors and VCC/2 biasing
Manufacturer
Maxim
Datasheet
1.MAX4174.pdf
(20 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MAX4275AGESA
Manufacturer:
MAXIM/美信
Quantity:
20 000
SOT23, Rail-to-Rail, Fixed-Gain
GainAmps/Open-Loop Op Amps
cause output phase reversal. A back-to-back SCR
structure at the input pins allows either input to safely
swing ±17V relative to V
internal op-amp inputs are diode clamped to either
supply rail for the protection of sensitive input stage cir-
cuitry. Current through the clamp diodes is limited by a
5kΩ resistor at the noninverting input, and by R
inverting input. An IN+ or IN- fault voltage as high as
±17V will cause less than 3.5mA of current to flow
through the input pin, protecting both the GainAmp and
the signal source from damage.
GainAmp fixed-gain amplifiers offer a precision, fixed
gain amplifier in a small package that can be used in a
variety of circuit board designs. GainAmp fixed-gain
amplifiers can be used in many op amp circuits that use
resistive negative feedback to set gain, and that do not
require other connections to the op-amp inverting input.
Both inverting and noninverting op-amp configurations
can be implemented easily using a GainAmp.
Figure 3. Input Protection
12
______________________________________________________________________________________
Applications Information
IN+
IN-
BIAS RESISTORS (MAX4175/MAX4275 ONLY)
EE
(Figure 3). Additionally, the
SCR
SCR
17V
V
17V
V
EE
EE
V
V
EE
CC
R
G
5k
V
V
EE
CC
G
at the
NOTE: INPUT STAGE PROTECTION INCLUDES
TWO 17V SCRs AND TWO DIODES AT THE INPUT STAGE.
The MAX4174/MAX4175/MAX4274/MAX4275 combine
both an op amp and gain-setting feedback resistors on
the same chip. Because the inverting input pin is actu-
ally tied to the R
input voltage range is different from the noninverting
input voltage range. Just as with a discrete design,
care must be taken not to saturate the inputs/output of
the core op amp, to avoid signal distortions or clipping.
The inverting inputs (IN_-) of the MAX4174/MAX4175/
MAX4274/MAX4275 must be within the supply rails or
signal distortion may result. The GainAmp’s inverting
input structure includes diodes to both supplies, such
that driving the inverting input beyond the rails may
cause signal distortions (Figure 1). For applications that
require sensing voltages beyond the rails, use the
MAX4281/MAX4282/MAX4284 open-loop op amps
(Figure 4).
MAX4174
MAX4175
MAX4274
MAX4275
R
F
GainAmp Input Voltage Range
G
input series resistor, the inverting
OUT