MAX4285 Maxim, MAX4285 Datasheet - Page 12
![no-image](/images/no-image-200.jpg)
MAX4285
Manufacturer Part Number
MAX4285
Description
The MAX4285/MAX4286 single and MAX4287/MAX4288/MAX4387/MAX4388 dual ADC buffer amplifiers feature high-speed performance and single +3V supply operation
Manufacturer
Maxim
Datasheet
1.MAX4285.pdf
(16 pages)
For example, a noninverting gain-of-two configuration
(R
cal amplifier input capacitance, generates a pole at
159MHz. Since this pole is within the amplifier band-
width, it jeopardizes stability. Reducing these 1kΩ
resistors to 100Ω extends the pole frequency to
1.59GHz, but affects output swing by adding 200Ω in
parallel with the amplifier’s load resistor. The typical
value for R
These amplifiers operate from a single +2.85V to +6.5V
power supply or from ±1.425V to ±3.25V dual supplies.
For single-supply operation, bypass V
a 0.1nF capacitor as close to the pin as possible, with a
0.1µF capacitor in parallel. If operating with dual sup-
plies, bypass each supply with capacitors to ground.
Observe the following guidelines:
•
•
•
•
•
The MAX4285/MAX4286/MAX4288 and MAX4388 fea-
ture a disable (DISABLE_) input that places the amplifi-
er in a low-power, high-output-impedance state. When
DISABLE_ is asserted, the amplifier’s output impedance
is typically 35kΩ. This high output impedance, com-
bined with the low 2pF output capacitance, make these
devices ideal for ADC input multiplexing applications or
switch applications. Typical enable/disable times are
40ns/50ns.
+3V/+5V, 250MHz, SOT23 ADC Buffer Amplifiers
with High-Speed Disable
12
F
A solid ground plane is essential for good high-fre-
quency behavior.
Where possible, use multiple ground vias.
Use a PC board with at least two layers. Avoid
areas of unreferenced copper-clad.
Keep signal traces as short and as straight as pos-
sible. Do not make sharp turns; round all trace
corners.
Use a constant-impedance board design if possi-
ble.
= R
______________________________________________________________________________________
G
Layout and Power-Supply Bypassing
) using 1kΩ resistors, combined with 2pF typi-
F
is 300Ω.
High-Speed Disable
CC
to ground with
These op amps are optimized for AC performance.
They are not designed to drive highly reactive loads,
which decrease phase margin and may produce
excessive ringing and oscillation. A small isolation
resistor (usually 20Ω to 30Ω) placed before the reactive
load reduces possible ringing and oscillation (Figure
1). At higher capacitive loads, AC performance is
dependent on the interaction of the load capacitance,
the isolation resistor, and on-board layout.
The MAX4285–MAX4288 and MAX4387/MAX4388 have
an output sink capability of 106mA and a source capa-
bility of 77mA. This high current ability allows them to
drive low-impedance and dynamic-impedance ADC
inputs. The linear output range of these devices is (V
+ 0.4V) to (V
not recommended due to reduced gain and phase
margin.
Figure 1. Using an Isolation Resistor (R
Loads
Output Capacitive Loading and Stability
R
G
CC
- 0.4V). Operation beyond this range is
R
F
Output Drive Capability
MAX4285
MAX4286
MAX4287
MAX4288
MAX4387
MAX4388
S
R
S
) for High Capacitive
C
I
C
I
EE