MAX9504B Maxim, MAX9504B Datasheet
MAX9504B
Related parts for MAX9504B
MAX9504B Summary of contents
Page 1
... The MAX9504A/MAX9504B operate from a single +2.7V to +5.5V supply and consume only 5mA of supply cur- rent. The low-power shutdown mode reduces supply current to 10nA, making the MAX9504A/MAX9504B ideal for low-voltage, battery-powered video applications. The MAX9504A/MAX9504B are available in tiny 6-pin µDFN (2mm x 2mm) and 6-pin SOT23 packages, and are specified over the -40° ...
Page 2
... 3.0V, CC (Note 2), 0 < V < 1.10V IN MAX9504B V = 4.5V < V < 1.75V IN MAX9504A 2.7V < V < 5.5V CC MAX9504B Sourcing 20Ω to GND L Sinking 20Ω OUT shorted GND CC SHDN = SHDN = 0V SHDN = -40°C to +85°C. Typical values CC A MIN ...
Page 3
... OUT P 100mV OUT P OUT P step OUT step OUT MAX9504A f = 100kHz MAX9504B f = 5MHz NTSC NTSC 250ns, bar time is 18µs, the beginning 2.5% and the ending 2.5% of the bar time are ignored 2T = 250ns 2T = 250ns, bar time is 18µs, the beginning 2 ...
Page 4
... OUT P 0 100 FREQUENCY (MHz) LARGE-SIGNAL GAIN FLATNESS vs. FREQUENCY 0 OUT P-P 0 0.1 0 -0.1 -0.2 -0.3 -0.4 -0.5 -0.6 0.01 0 100 FREQUENCY (MHz) POWER-SUPPLY REJECTION RATIO vs. FREQUENCY -10 -20 -30 -40 -50 MAX9504B -60 -70 MAX9504A -80 -90 0.001 0.01 0 FREQUENCY (MHz) ...
Page 5
... TEMPERATURE (° MAX9504 toc15 -0 -0.2 25mV/div V OUT -0.2 50mV/div -0 +25°C, unless otherwise noted MAX9504B INPUT OFFSET VOLTAGE vs. TEMPERATURE 0.19 0. 0. 0.15 0.14 -40 - TEMPERATURE (°C) LARGE-SIGNAL STEP RESPONSE MAX9504 toc14 V 500mV/div V 1V/div 10ns/div DIFFERENTIAL GAIN AND PHASE ...
Page 6
... +25°C, unless otherwise noted OUT RESPONSE TO NTC-7 TEST SIGNAL (MAX9504B) MAX9504 toc18 V IN 500mV/div V OUT 1V/div 10µs/div OUT RESPONSE TO A FIELD SQUARE WAVE (MAX9504B) MAX9504 toc20 500mV/div V OUT 1V/div 2ms/div Pin Description . CC ...
Page 7
... R2 ONLY GND The MAX9504A/MAX9504B amplify DC-coupled video signals with a gain of +2V/V (+6dB). The MAX9504B features a 160mV input offset voltage (V a video signal input range to ground without clipping the output sync tip. The MAX9504B output voltage is the sum of the input voltage and the input offset voltage gained factor of 2 ...
Page 8
... Figure 2. 2nd-Order Butterworth LPF with MAX9504 8 _______________________________________________________________________________________ 320mV result, the MAX9504B output stage always operates in the linear mode. Even if the input signal is at ground, the MAX9504B output is at 320mV. At the output of a video current DAC, the blank level of the chroma signal is usually between 500mV to 650mV ...
Page 9
RECONSTRUCTION LPF VIDEO CURRENT DAC C1 R1 120pF 150Ω Figure 3. 3rd-Order Butterworth LPF with MAX9504 2nd-Order Butterworth Lowpass Filter Realization Table 1 shows the normalized 2nd-order Butterworth LPF component values at 1 rad/s with a source/load impedance of ...
Page 10
... AC short at the color subcarrier fre- quency of 3.58MHz for NTSC or 4.43MHz for PAL. This circuit relies upon the feature that the MAX9504A/ MAX9504B can drive two loads at the same time. Cn3 (F) Ln1 (H) 0.06 1 ...
Page 11
... RECONSTRUCTION LPF 6.8pF CHROMA 4.7µH VIDEO CURRENT DAC 120pF 150Ω Figure 7. Y/C-to-Composite Mixer and Driver Circuit ______________________________________________________________________________________ 3V/5V, 6dB Video Amplifiers with High Output-Current Capability MAX9504B 120pF 150Ω SHDN GND MAX9504A 120pF 150Ω SHDN GND 0.1µ ...
Page 12
... Figure 8). For V ≥ 4.5V, C5 and C6 are 22µF CC capacitors. Layout and Power-Supply Bypassing The MAX9504A/MAX9504B operate from a single 2.7V to 5.5V supply. Bypass the supply with a 0.1µF capaci- tor as close to V possible. Maxim recommends using CC 3-POLE RECONSTRUCTION LPF ...
Page 13
... MAX9504A GND 2 5 MAX9504B SOT23-6 ______________________________________________________________________________________ 3V/5V, 6dB Video Amplifiers with High Output-Current Capability 2.7V TO 5.5V MAX9504A MAX9504B 160mV OFFSET MAX9504B 120pF 150Ω ONLY 580Ω 1.2kΩ PROCESS: BiCMOS FB SHDN V CC Typical Operating Circuit V CC 0.1µ SHDN Z = 75Ω 0 75Ω ...
Page 14
... Video Amplifiers with High Output-Current Capability (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages.) 14 ______________________________________________________________________________________ Package Information ...
Page 15
... For the latest package outline information www.maxim-ic.com/packages.) D XXXX XXXX XXXX SAMPLE PIN 1 INDEX AREA MARKING 7 A1 -DRAWING NOT TO SCALE- ______________________________________________________________________________________ 3V/5V, 6dB Video Amplifiers with High Output-Current Capability ...
Page 16
... BSC -DRAWING NOT TO SCALE- Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. 16 ____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 © ...