MAX9203 Maxim, MAX9203 Datasheet
MAX9203
Available stocks
Related parts for MAX9203
MAX9203 Summary of contents
Page 1
... The MAX9201/ MAX9202/MAX9203 consume only 9mW per compara- tor when powered from a +5V supply. The MAX9202/MAX9203 feature output latches with TTL compatible inputs. The comparator output states are held when the latch inputs are driven low. The MAX9201 provides all the same features as the MAX9202/MAX9203 with the exception of the latches ...
Page 2
... DD Differential Input Voltage..................(V EE Common Mode Input Voltage ..........(V EE Latch Input Voltage (MAX9202/MAX9203 only) .....................-0. Output Short-Circuit Duration To GND ......................................................................Continuous To V ..................................................................................1min DD Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and function- al operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied ...
Page 3
... LATCH_ = logic high CONDITIONS MAX9201 I Note 5 MAX9202 EE MAX9203 MAX9201 Note 5 MAX9202 DD MAX9203 MAX9201 +5V MAX9202 MAX9203 = 0, LATCH_ = logic high CONDITIONS V = 5mV +25° 15pF, PD -40°C to +85° 2mA A OUT V = 5mV +25°C ...
Page 4
Low Cost, 7ns, Low-Power Voltage Comparators (V = +5V -5V +5V, GND = INPUT OFFSET VOLTAGE vs. TEMPERATURE 1.5 1.0 0.5 0 -0.5 -1.0 -1.5 -40 - TEMPERATURE (°C) ...
Page 5
V = -5V +5V, GND = RESPONSE TIME vs. TEMPERATURE (5mV OVERDRIVE) 8.0 7.8 7.5 7.3 t PD+ 7.0 6.8 6.5 -40 -30 -20 - ...
Page 6
... Solder the device directly to the printed circuit board instead of using a socket. As with all high-speed comparators, the high gain-band- width product of the MAX9201/MAX9202/ MAX9203 can create oscillation problems when the input traverses the linear region. For clean output switching without oscilla- tion or steps in the output waveform, the input must meet minimum slew-rate requirements (0 ...
Page 7
... The MAX9201/MAX9202/MAX9203 can be powered from separate analog and digital supplies or from a sin- gle +5V supply. The analog supply can range from +5V to +10V with V grounded for single-supply operation EE (Figures 1a and 1b) or from a split ±5V supply (Figure 1c). The V digital supply always requires +5V. ...
Page 8
... Chip Information MAX9201 TRANSISTOR COUNT: 348 MAX9202 TRANSISTOR COUNT: 176 MAX9203 TRANSISTOR COUNT: 116 PROCESS: Bipolar Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...