MAX4597 Maxim, MAX4597 Datasheet
MAX4597
Available stocks
Related parts for MAX4597
MAX4597 Summary of contents
Page 1
... General Description The MAX4594–MAX4597 single-pole/single-throw (SPST) analog switches operate from a single +2.0V to +5.5V supply. The MAX4594/MAX4596 switches are normally open (NO), and the MAX4595/MAX4597 are normally closed (NC). The MAX4596/MAX4597 pinouts are optimized for the highest SC70 package off-isola- tion available. These switches have 10Ω max on-resistance (R with 1.5Ω ...
Page 2
... Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. ELECTRICAL CHARACTERISTICS— ...
Page 3
... NC L 300Ω 35pF, Figure 1nF Figure 2 MIN TYP MAX = +25°C 2 MAX4594/ 80 MAX4595 = MAX4596/ 83 MAX4597 = +25° +25° +25° +25°C 0.05 2 MIN MAX MIN TYP MAX 0 = +25° MIN MAX 2 ...
Page 4
... Note 2: Parameters are 100% tested at +25°C only, and guaranteed by correlation at the full-rated temperature. Note 3: Algebraic convention is used in this data sheet; the most negative value is shown in the minimum column. Note 4: Flatness is defined as the difference between the maximum and minimum values of on-resistance as measured over the specified analog signal ranges. ...
Page 5
... SUPPLY VOLTAGE OFF 5.0 2.0 2.5 3.0 3.5 4.0 SUPPLY VOLTAGE (V) 0.1 ON-LOSS 0.01 OFF-ISOLATION 0.001 0.0001 1 10 100 1000 0.01 FREQUENCY (MHz) NAME MAX4596 MAX4597 µDFN SC70 µDFN COM 4 4 — — GND — — — ...
Page 6
... Analog Signal Levels Analog signals can range over the supply voltage (V+ to GND) with on-resistance changing very little over the entire range (see Typical Operating Characteristics). The MAX4594–MAX4597 are bidirectional, so the NO, NC, and COM pins can be used either as inputs or outputs. POSITIVE SUPPLY D1 ...
Page 7
... OUT OFF-ISOLATION = 20log OUT ON-LOSS = 20log V IN Figure 5. Channel On-/Off-Capacitance ≤ 5ns ≤ 5ns t 50 OUT 90% 90 OFF V+ 50 OUT 90% 90 OFF ON V+ 10nF V+ COM GND MAX4594 MAX4595 MAX4596 MAX4597 0 OR 2.4V 7 ...
Page 8
... Pin Configurations/Functional Diagrams/Truth Table (continued) TOP VIEW COM COM N. GND 4 IN GND MAX4594 µDFN 8 _______________________________________________________________________________________ COM 2 5 N.C. 3 GND MAX4595 MAX4596 µDFN µDFN TRANSISTOR COUNT COM 2 5 N. GND MAX4597 µDFN Chip Information ...
Page 9
... For the latest package outline information www.maxim-ic.com/packages.) TOPMARK 2 AAA PIN 1 INDEX AREA 1 D TOP VIEW -DRAWING NOT TO SCALE- _______________________________________________________________________________________ Low-Voltage, Single-Supply, 10Ω SPST CMOS Analog Switches ...
Page 10
... For the latest package outline information www.maxim-ic.com/packages.) Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...