MAX4676 Maxim, MAX4676 Datasheet
![no-image](/images/no-image-200.jpg)
MAX4676
Related parts for MAX4676
MAX4676 Summary of contents
Page 1
... SOT23 package. The MAX4675 has a single normally open (NO) switch, and the MAX4676 has a single normally closed (NC) switch. The MAX4675/MAX4676 operate from either a single +2.7V to +5.5V or dual ±2.7V to ±5.5V supplies, mak- ing them ideal for use in digital card applications and single-ended 75Ω ...
Page 2
... Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability ...
Page 3
ELECTRICAL CHARACTERISTICS—DUAL SUPPLIES (continued) (V+ = +5V ±10 -5V ±10%, GND = +25°C.) (Notes PARAMETER SYMBOL Charge Injection Q Off-Isolation V ISO On-Channel Bandwidth BW (-3dB Off-Capacitance ...
Page 4
... I+ Note 2: Parameters are 100% tested at +25°C only and guaranteed by correlation through the full-rated temperature range. Note 3: The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in this data sheet. Note 4: Flatness is defined as the difference between the maximum and minimum value of R analog signal ranges ...
Page 5
A ON-RESISTANCE vs. V (DUAL SUPPLIES) COM 4 ±2.5V 3.5 3 ±3V 2.5 2 ±5V 1.5 1.0 0 (V) COM ...
Page 6
... SUPPLY VOLTAGE (V) POWER-SUPPLY CURRENT vs. TEMPERATURE -10 -40 - TEMPERATURE (°C) PIN MAX4675 MAX4676 — — _______________________________________________________________________________________ Typical Operating Characteristics (continued) TURN-ON/TURN-OFF TIMES vs. TEMPERATURE (DUAL SUPPLIES) 140 120 100 t ...
Page 7
... OUT COM Figure 2. Switching Time MAX4675 MAX4676 R GEN GEN GND IN Figure 3. Charge Injection _______________________________________________________________________________________ 3Ω Single SPST Analog Switches Power-supply bypassing improves noise margin and prevents switching noise from propagating from the V+ supply to other components. A 0.1µF capacitor connect- ed from V+ to GND is adequate for most applications ...
Page 8
... Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 © 2000 Maxim Integrated Products Timing Diagrams/Test Circuits (continued 2.4V CAPACITANCE METER 1MHz V- Figure 5. Channel On/Off-Capacitance Printed USA is a registered trademark of Maxim Integrated Products. V+ 10nF MAX4675 MAX4676 V+ COM 2. GND V- V- Package Information ...