MAX4696 Maxim, MAX4696 Datasheet
MAX4696
Related parts for MAX4696
MAX4696 Summary of contents
Page 1
... ON gle +2.0V to +5.5V supply. The MAX4696/MAX4697 are single-pole/single-throw (SPST) analog switches, and the MAX4698 is a single-pole/double-throw (SPDT) ana- log switch. The MAX4696 is a normally open (NO) switch, and the MAX4697 is a normally closed (NC) switch. When powered from a 2.7V supply, these devices feature 35Ω (max with 2Ω ...
Page 2
... On-Resistance Flatness R FLAT(ON) (Note 5) NO, NC Off-Leakage I NO(OFF) Current (Note 3) I NC(OFF) COM Off-Leakage Current (Note 3) I COM_(OFF) (MAX4696, MAX4697 only) COM On-Leakage Current I COM_(ON) (Note 3) DYNAMIC CHARACTERISTICS Turn-On Time (Note _______________________________________________________________________________________ Continuous Power Dissipation (T ✕ UCSP (derate 10.1mW/°C at +70°C)....................808mW Operating Temperature Range ...........................-40° ...
Page 3
Analog Switches in UCSP Package ELECTRICAL CHARACTERISTICS—Single +3V Supply (continued) (V+ = +2.7V to +3.3V +1.4V +25°C.) (Notes PARAMETER SYMBOL Turn-Off Time (Note 3) t OFF Break-Before-Make Time t BBM (MAX4698 ...
Page 4
... A PARAMETER SYMBOL On-Resistance Flatness R FLAT(ON) (Note 5) NO, NC Off-Leakage I , NO(OFF) Current (Note 3) I NC(OFF) COM Off-Leakage Current (MAX4696, MAX4697 only) I COM_(OFF) (Note 3) COM On-Leakage Current I COM_(ON) (Note 3) Turn-On Time (Note Turn-Off Time (Note 3) t OFF Break-Before-Make Time t ...
Page 5
Analog Switches in UCSP Package (T = +25°C, unless otherwise noted.) A ON-RESISTANCE vs. V COM + +2. +3. + 0.5 1.0 1.5 2.0 ...
Page 6
... A1 A2 — Applications Information Where the MAX4696/MAX4697/MAX4698 have a +3.3V supply, IN may be driven low to GND and driven high to 5.5V. Driving IN rail-to-rail minimizes power con- sumption. Logic inputs accept up to +5.5V regardless of supply voltage. Analog Signal Levels Analog signals that range over the entire supply volt- ...
Page 7
... Protection diode D1 also protects against some overvoltage situations. No damage will result on the circuit in Figure 6 if the supply voltage is below the absolute maximum rating and if a fault voltage up to the absolute maximum rating is applied to an analog signal terminal. MAX4696 V+ MAX4697 MAX4698 V+ NO ...
Page 8
... Diodes TRANSISTOR COUNT: 50 ∆V OUT OFF ON ON OFF Q = (∆V )(C ) OUT L IN DEPENDS ON SWITCH CONFIGURATION; INPUT POLARITY DETERMINED BY SENSE OF SWITCH. V OUT OFF-ISOLATION = 20log OUT ON-LOSS = 20log OUT CROSSTALK = 20log V IN POSITIVE SUPPLY D1 V+ MAX4696 MAX4697 MAX4698 NO COM GND Chip Information ...
Page 9
... For the latest package outline information www.maxim-ic.com/packages.) Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...