DG412F Maxim, DG412F Datasheet
DG412F
Available stocks
Related parts for DG412F
DG412F Summary of contents
Page 1
... On-resistance is 35Ω (max) and is matched between switches to 1.5Ω (max) at +25°C. The DG411F has four normally closed (NC) switches. The DG412F has four normally open (NO) switches. The DG413F has two NC and two NO switches. These CMOS switches operate with dual power supplies rang- ing from ± ...
Page 2
... When the power is off, the maximum range is -40V to +40V. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. ELECTRICAL CHARACTERISTICS— ...
Page 3
Quad, Rail-to-Rail, Fault-Protected, ELECTRICAL CHARACTERISTICS—±15V Dual Supplies (continued) (V+ = +15V -15V +2.4V +25°C.) (Notes PARAMETER SYM NO_ or NC_ Leakage Current I NO_ COM_ Leakage ...
Page 4
Quad, Rail-to-Rail, Fault-Protected, SPST Analog Switches ELECTRICAL CHARACTERISTICS—±15V Dual Supplies (continued) (V+ = +15V -15V +2.4V +25°C.) (Notes PARAMETER SYM Supply Current GND Supply Current ...
Page 5
... Note 3: Electrical specifications at -40°C are not production tested and guaranteed by design. Note 4: ∆R = ∆R - ∆R ON ON(MAX) ON(MIN) Note 5: Leakage parameters are 100% tested at maximum rated temperature and with dual supplies and guaranteed by design at +25°C. Note 6: Guaranteed by design. Note 7: Off-Isolation = 20 log [V /(V COM 10 Note 8: Between any two switches ...
Page 6
Quad, Rail-to-Rail, Fault-Protected, SPST Analog Switches (T = +25°C, unless otherwise noted.) A ON-RESISTANCE vs. V COM (DUAL SUPPLIES) 100 +10V V+ = +15V V- = -10V V- = -15V ...
Page 7
Quad, Rail-to-Rail, Fault-Protected +25°C, unless otherwise noted.) A TURN-ON/TURN-OFF TIMES vs. SUPPLY VOLTAGE (SINGLE SUPPLY) 200 150 100 OFF V- = GND SUPPLY VOLTAGE (V+) FREQUENCY RESPONSE ...
Page 8
Quad, Rail-to-Rail, Fault-Protected, SPST Analog Switches (T = +25°C, unless otherwise noted.) A INPUT OVERVOLTAGE vs. OUTPUT NO_ NC_ INPUT V COM_ OUTPUT 20ms/div FAULT STEP RESPONSE (NEGATIVE INPUT NO_ NC_ INPUT V COM_ ...
Page 9
... COM_ terminal (or vice versa), allowing true rail-to-rail signal operation. Third, the DG411F/DG412F/DG413F have the same fault-protection performance on any of the NO_, NC_, or COM_ switch inputs. Operation is identical for both fault polarities. The fault protection extends to ± ...
Page 10
... The DG411F/DG412F/DG413F operate with bipolar supplies between ±4.5V and ±20V. The V+ and V- sup- plies need not be symmetrical, but their difference can- not exceed the absolute maximum rating of 44V. The DG411F/DG412F/DG413F operate from a single supply between +9V and +36V when V- is connected to GND. Ordering Information (continued) ...
Page 11
... V- IS CONNECTED TO GND (0V) FOR SINGLE-SUPPLY OPERATION. Figure 2. Switch Turn-On/Turn-Off Times ______________________________________________________________________________________ SPST Analog Switches Test Circuits/Timing Diagrams NORMALLY OPEN SWITCH CONSTRUCTION HIGH FAULT LOW FAULT IN_ 10V 0V 10V V OUT COM_ V OUT OFF P1 COM_ N1 DG411F DG412F DG413F 50% 90% 90 ...
Page 12
... V GEN IN_ V OUT V COM_ OUT GND ∆V TRANSFER ERROR Q WHEN THE CHANNEL TURNS OFF V+ V+ NO_ V+ NC_ DG411F DG412F IN_ DG413F COM_ GND < 5ns F t < 5ns R 50% 90% t BBM 3V 0V ∆V OUT IS THE MEASURED VOLTAGE DUE TO CHARGE- OUT Q = ∆ ...
Page 13
... IN1 15 2 COM2 COM1 14 NO2 NO1 DG412F 5 12 N.C. GND 11 6 NO3 NO4 10 COM3 7 COM4 9 8 IN3 IN4 DIP/TSSOP/SO DG412F SWITCHES LOGIC SWITCH OFF NETWORK ANALYZER 50Ω 50Ω REF 50Ω 50Ω 16 IN2 15 COM2 14 NC2 13 V+ DG413F 12 N.C. 11 NC3 10 COM3 9 ...
Page 14
... Quad, Rail-to-Rail, Fault-Protected, SPST Analog Switches (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages.) 14 ______________________________________________________________________________________ Package Information ...
Page 15
... Quad, Rail-to-Rail, Fault-Protected, (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages.) ______________________________________________________________________________________ SPST Analog Switches Package Information (continued) 15 ...
Page 16
... For the latest package outline information www.maxim-ic.com/packages.) Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...