MAX314F Maxim, MAX314F Datasheet
MAX314F
Available stocks
Related parts for MAX314F
MAX314F Summary of contents
Page 1
... The MAX312F has four normally closed (NC) switches. The MAX313F has four normally open (NO) switches. The MAX314F has two NC and two NO switches. These CMOS switches operate with dual power supplies rang- ing from ±4.5V to ±20V or a single supply between +9V and +36V ...
Page 2
... When the power is off, the maximum range is -40V to +40V. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. ELECTRICAL CHARACTERISTICS— ...
Page 3
... COM_ Leakage Current I (Note 6) Fault-Trip Threshold ± Fault Response Time ± Fault Recovery Time SWITCH DYNAMICS Turn-On Time Turn-Off Time Break-Before-Make Time Delay (MAX314F Only) (Note 7) Charge Injection NO_ or NC_ Off-Capacitance C COM_ Off-Capacitance C COM_(OFF) COM_ On-Capacitance C COM_(ON) Off-Isolation (Note 8) Channel-to-Channel Crosstalk ...
Page 4
Quad, Rail-to-Rail, Fault-Protected, SPST Analog Switches ELECTRICAL CHARACTERISTICS—±15V Dual Supplies (continued) (V+ = +15V -15V +2.4V +25°C.) (Notes PARAMETER SYM Supply Current GND Supply Current ...
Page 5
... SYM COM_ Leakage Current (Note 6) Fault Response Time Fault Recovery Time SWITCH DYNAMICS Turn-On Time Turn-Off Time Break-Before-Make Time Delay (MAX314F Only) (Note 6) Charge Injection LOGIC INPUT Input Logic High Input Logic Low Input Leakage Current (Note 6) POWER SUPPLY Power-Supply Range V+ Supply Current Note 2: The algebraic convention is used in this data sheet ...
Page 6
Quad, Rail-to-Rail, Fault-Protected, SPST Analog Switches (T = +25°C, unless otherwise noted.) A ON-RESISTANCE vs. V COM (DUAL SUPPLIES + - +10V V- = -10V +15V V- = -15V ...
Page 7
Quad, Rail-to-Rail, Fault-Protected +25°C, unless otherwise noted.) A TURN-ON/TURN-OFF TIME vs. SUPPLY VOLTAGE (SINGLE SUPPLY) 200 160 120 OFF V- = GND SUPPLY VOLTAGE (V+) FREQUENCY RESPONSE 20 V+ ...
Page 8
Quad, Rail-to-Rail, Fault-Protected, SPST Analog Switches (T = +25°C, unless otherwise noted.) A INPUT OVERVOLTAGE vs. OUTPUT 2ms/div FAULT RECOVERY TIME (NEGATIVE INPUT) 1µs/div FAULT RESPONSE TIME (NEGATIVE INPUT) 1µs/div 8 _______________________________________________________________________________________ Typical Operating Characteristics (continued) FAULT RECOVERY TIME (POSITIVE ...
Page 9
... COM_ terminal (or vice versa), allowing true rail-to-rail signal operation. Third, the MAX312F/MAX313F/MAX314F have the same fault-protection performance on any of the NO_, NC_, or COM_ switch inputs. Operation is identical for both fault polarities. The fault protection extends to ± ...
Page 10
... The V+ and V- sup- plies need not be symmetrical, but their difference can- not exceed the absolute maximum rating of 44V. The MAX312F/MAX313F/MAX314F operate from a sin- gle supply between +9V and +36V when V- is connect GND. Ordering Information (continued) ...
Page 11
... V- IS CONNECTED TO GND (0V) FOR SINGLE-SUPPLY OPERATION. Figure 2. Switch Turn-On/Turn-Off Times ______________________________________________________________________________________ SPST Analog Switches Test Circuits/Timing Diagrams NORMALLY OPEN SWITCH CONSTRUCTION HIGH FAULT LOW FAULT IN_ 10V 0V 10V V OUT COM_ V OUT OFF P1 COM_ N1 MAX312F MAX313F MAX314F 50% 90% 90 ...
Page 12
... Quad, Rail-to-Rail, Fault-Protected, SPST Analog Switches V IN_ IN_ IN_ MAX314F GND V- IS CONNECTED TO GND (0V) FOR SINGLE-SUPPLY OPERATION. Figure 3. MAX314F Break-Before-Make Interval V+ V IN_ V+ IN_ NO_ OR NC_ MAX312F MAX313F MAX314F GND V- IS CONNECTED TO GND (0V) FOR SINGLE-SUPPLY OPERATION. Figure 4. Charge Injection Figure 5. COM_, NO_, NC_ Capacitance ...
Page 13
... NO3 NO4 10 COM3 COM4 IN3 IN4 DIP/SO MAX313F LOGIC SWITCH LOGIC 0 OFF NETWORK ANALYZER 50Ω 50Ω REF 50Ω 50Ω 16 IN2 15 COM2 14 NC2 13 V+ MAX314F 12 N.C. 11 NC3 10 COM3 9 IN3 DIP/SO MAX314F SWITCHES SWITCHES OFF ON ON OFF 13 ...
Page 14
... Quad, Rail-to-Rail, Fault-Protected, SPST Analog Switches (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages.) 14 ______________________________________________________________________________________ Package Information ...
Page 15
... For the latest package outline information www.maxim-ic.com/packages.) Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...