MAX351 Maxim, MAX351 Datasheet - Page 6

• Manufacturer Part Number: MAX351
• Manufacturer: Maxim

The main limitation of supply voltages other than
±15V is reduced analog-signal range. The MAX351/
MAX352/MAX353 operate with ±5V to ±20V bipolar
supplies. The Typical Operating Characteristics graphs
show typical on resistance (R
±5V supplies. (Switching times increase by a factor of
two or more for operation at ±5V.) The MAX351/
MAX352/MAX353 can operate from +10V to +30V
unipolar supplies. Each device can also be powered
from unbalanced supplies such as +24V and -5V.
Connect V- to 0V when operating with a single supply.
VL must be connected to +5V to be TTL compatible or
to V+ for CMOS-logic input levels.
Precision, Quad, SPST Analog Switches
Figure 1. Overvoltage Protection Using External Blocking
Diodes
6
______________________________________________________________Pin Description
__________Applications Information
2, 15, 10, 7
3, 15, 11, 6
1, 16, 9, 8
Operation with Supplies Other than ±15V
DIP/SO
_______________________________________________________________________________________
12
13
4
5
V g
PIN
NO_
15, 14, 7, 6
16, 13, 8, 5
1, 12, 9, 4
QFN
10
11
2
3
V+
COM1–COM4
V-
V+
V-
NO or NC
ON
IN1–N4
NAME
GND
V+
V
V-
) for ±15V, ±10V, and
L
COM_
Logic Control Input
Analog Switch Common Terminal
Analog Switch NO or NC Terminal
Negative-Supply Voltage Input
Ground
Logic Supply Voltage
Positive-Supply Voltage Input—Connected To Substrate
Proper power-supply sequencing is recommended for
all CMOS devices. Do not exceed the absolute maxi-
mum ratings because stresses beyond the listed rat-
ings may cause permanent damage to the devices.
Always sequence V+ first, followed by VL, V-, and logic
inputs. If power-supply sequencing is not possible, add
two small signal diodes in series with the supply pins
for overvoltage protection (Figure 1). Adding diodes
reduces the analog signal range to 1V below V+ and
1V below V-, but low switch resistance and low-leakage
characteristics are unaffected. Device operation is
unchanged, and the difference between V+ to V-
should not exceed +44V.
FUNCTION
Overvoltage Protection