MAX4524 Maxim, MAX4524 Datasheet
MAX4524
Available stocks
Related parts for MAX4524
MAX4524 Summary of contents
Page 1
... Rev 2; 6/07 ________________General Description The MAX4524/MAX4525 are low-voltage, single-supply CMOS analog switches configured as a 4-channel mul- tiplexer/demultiplexer (MAX4524) and a double- pole/double-throw (DPDT) switch (MAX4525). Both have an inhibit input to simultaneously open all signal paths. These devices operate from a single supply of +2V to +12V and are optimized for operation with +3V or +5V supplies ...
Page 2
... V+ = 4.5V 1mA 3.5V COM COM V+ = 4.5V 1mA 3.5V COM COM V+ = 5.5V 1mA; COM V = 1.5V, 2.5V, 3.5V COM V+ = 5.5V 1V, 4.5V 4.5V COM MAX4524 V+ = 5.5V 1V, 4.5V 4.5V, 1V COM MAX4525 MAX4524 V+ = 5.5V 4.5V, 1V COM MAX4525 2.4V A INH 0.8V A INH = +70°C) A MIN TYP MAX TEMP UNITS (Note +25°C 90 ...
Page 3
... +25° -10 , unless otherwise noted. Typical values are at MAX MIN TYP TEMP (Note +25°C 190 C, E +25° -10 +25°C -2 MAX4524 C, E -50 +25°C -1 MAX4525 C, E -25 MAX UNITS 150 ns 200 120 ns 180 150 ns 200 ...
Page 4
... Note 6: Guaranteed by design, not production tested. Note 7: TDFN parts are tested at +25°C and are guaranteed by design and correlation over the entire temperature range. 4 _______________________________________________________________________________________ = 0.5V unless otherwise noted. Typical values are MIN MAX CONDITIONS MAX4524 V+ = 3.6V 3V, 1V COM MAX4525 2.0V A INH 0.5V ...
Page 5
... TEMPERATURE ( C) SUPPLY CURRENT vs. TEMPERATURE COM 100 0V, 5V INH -50 - TEMPERATURE ( C) FREQUENCY RESPONSE MAX4524/25-08 0 -10 ON LOSS -20 -30 OFF LOSS -40 -50 ON PHASE -60 -70 -80 -90 -100 -110 50 IN AND OUT -120 0 100 FREQUENCY (MHz) NO OFF 75 100 ...
Page 6
... - - (V) ADD_ INH MAX4524 MAX4525 NAME 1 — NO2 — 1 NOA 2 — NO3 — 2 COMA 3 — NO1 — 3 NCA 4 4 INH 5 5 GND 6 — ADDB — ...
Page 7
... Information Power-Supply Considerations The MAX4524/MAX4525’s construction is typical of most CMOS analog switches. They have two supply pins: V+ and GND. V+ and GND are used to drive the internal CMOS switches and set the limits of the analog voltage on any switch. Reverse ESD-protection diodes are internally connected between each analog signal pin and both V+ and GND ...
Page 8
... At room temperature, they actually “work” with a single supply at near or below +1.7V, although as supply voltage decreases, switch on-resis- tance and switching times become very high. _________________________________Test Circuits/Timing Diagrams (continued ADDA NO0 ADDB NO1–NO3 MAX4524 V INH INH COM GND ADD NO_ ...
Page 9
... ADD ADD NO_, NC_ 50 MAX4525 INH COM_ GND REPEAT TEST FOR EACH SECTION. Figure 3. Break-Before-Make Interval V+ V+ CHANNEL ADDB SELECT MAX4524 ADDA MAX4525 V INH INH COM_ GND 50 REPEAT TEST FOR EACH SECTION. Figure 4. Charge Injection _______________________________________________________________________________________ Low-Voltage, Single-Supply Multiplexer and Switch V+ ...
Page 10
... OFF-ISOLATION IS MEASURED BETWEEN COM AND "OFF" NO TERMINAL ON EACH SWITCH. ON-LOSS IS MEASURED BETWEEN COM AND "ON" NO TERMINAL ON EACH SWITCH. CROSSTALK (MAX4524) IS MEASURED FROM ONE CHANNEL ( OTHER CHANNEL. SIGNAL DIRECTION THROUGH SWITCH IS REVERSED; WORST VALUES ARE RECORDED. Figure 5. Off-Isolation, On-Loss, and Crosstalk ...
Page 11
... Topographies MAX4524 NO2 N.C. V+ N.C. N.C. NO3 NO1 INH GND N.C. N.C. ADDB 0.053" (1.35mm) TRANSISTOR COUNT: 219 SUBSTRATE CONNECTED TO V+ ______________________________________________________________________________________ Low-Voltage, Single-Supply Multiplexer and Switch N.C. N.C. N.C. NOA COM COMA N.C. 0.069" (1.75mm) NCA NO0 ADDA INH N.C. N. Connection MAX4525 V+ N.C. N.C. COMB NOB 0.069" (1.75mm) NCB N.C. GND N.C. ADD 0.053" ...
Page 12
... Low-Voltage, Single-Supply Multiplexer and Switch (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) 12 ______________________________________________________________________________________ Package Information ...
Page 13
... For the latest package outline information go to www.maxim-ic.com/packages.) ______________________________________________________________________________________ Low-Voltage, Single-Supply Multiplexer and Switch Package Information (continued) 13 ...
Page 14
... Revision History Pages changed at Rev 13,14 Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...