TMPM382FWFG Toshiba, TMPM382FWFG Datasheet - Page 487

• Manufacturer Part Number: TMPM382FWFG
• Manufacturer: Toshiba

Specifications of TMPM382FWFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 128K
• Rom Type: Flash
• Ram (kbytes): 12K
• Number Of Pins: 64
• Package: QFP(14x14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 1
• I2c/sio (ch): 1
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 10
• 16-bit Timer / Counter: 6
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

Example: Threshold of 0/1 determination is set to 2.5T with the <RMCDATL6:0> bit.
(3)
Data bit
waveform
Threshold of 0/1
determination
Determination
result
exceeds the threshold, the bit is determined as “1”. If not, the bit is determined as “0”.
interrupt can be generated in each falling edge of the data bit. Using this interrupt together with a
16-bit timer enables the determination to be done by software.
a Remote Control Signal in a Phase Method”.
Based on a falling edge cycle, the data bit is determined as 0 or 1.
Configure a threshold of the determination with the RMCRCR3 <RMCDATL6:0> bit. If the cycle
By setting ”1” to the RMCRCR2 <RMCEDIEN> bit, a remote control signal input falling edge
The following shows how the data bit is determined as “0” or “1”.
As for data bit determination of a remote control signal in a phase method, see 16.3.1.10 “Receiving
Settings of Data Bit Determination
T
TMPM380/M382 - 17 / 25 -
T
Remote control input falling edge interrupt
T
“0”
T
T
T
“1”
T
T
“0”
T
TMPM380/M382
T