BTS 5030-2EKA Infineon Technologies, BTS 5030-2EKA Datasheet - Page 21

• Manufacturer Part Number: BTS 5030-2EKA
• Manufacturer: Infineon Technologies

Specifications of BTS 5030-2EKA

• Packages: PG-DSO-14
• Channels: 2.0
• Ron @ Tj = 25°c: 30.0 mOhm
• Recommended Operating Voltage Min.: 5.0 V
• Recommended Operating Voltage Max.: 28.0 V
• Il(sc): 36.0 A

6
The device provides integrated protection functions. These functions are designed to prevent the destruction of
the IC from fault conditions described in the data sheet. Fault conditions are considered as “outside” normal
operating range. Protection functions are designed for neither continuous nor repetitive operation.
6.1
In case of loss of the module ground and the load remains connected to ground, the device protects itself by
automatically turning OFF (when it was previously ON) or remains OFF, regardless of the voltage applied on IN
pins.
In case of loss of device ground, it’s recommended to use input resistors between the microcontroller and the
BTS5030-2EKA to ensure switching OFF of channels.
In case of loss of module or device ground, a current (
the situation.
Z
Figure 14
6.2
Between
where the switching ON and OFF can takes place.
If the supply voltage is below the undervoltage mechanism
supply voltage is above the undervoltage mechanism
is ON, protection functions are operational. Nevertheless, the diagnosis is not guaranteed until
range.
Data Sheet
PROFET™+ 12V
GND
can be either resistor or diode.
Figure 15
V
R
R
R
SENSE
R
S(UV)
DSEL
DEN
IN
Protection Functions
Loss of Ground Protection
Loss of Ground Protection with External Components
Undervoltage Protection
and
sketches the undervoltage mechanism.
R
V
IS
S(OP)
, the undervoltage mechanism is triggered.
DEN
INx
DSEL
ZD
IS
ESD
Z
IS(AZ)
V
S(UV)
V
S(OP)
21
I
LOGIC
OUT(GND)
represents the minimum voltage the switch can hold ON.
, then the device can be switched ON. When the switch
V
S(UV)
GND
Z
GND
) can flow out of the DMOS.
, the device is OFF (turns OFF). As soon as the
Z
V
D(AZ)
S
V
Loss of ground protection.svg
S(OP)
Z
DS(AZ)
represents the minimum voltage
OUTx
Protection Functions
Rev. 2.1, 2011-09-01
BTS5030-2EKA
Figure 14
I
OUT(GND)
V
S
is in the
sketches
V
BAT
V
NOM