TLE 6258-2G Infineon Technologies, TLE 6258-2G Datasheet

no-image

TLE 6258-2G

Manufacturer Part Number
TLE 6258-2G
Description
Manufacturer
Infineon Technologies
Datasheet

Specifications of TLE 6258-2G

Packages
PG-DSO-8
Transmission Ratemax
20.0 kbit/s
Quiescent Current (max.)
< 40 µA standby mode
Bus Wake-up Capability
Yes
Additional Features
ENN, Vcc
Wake-up Inputs
Bus wake-up
Data Sheet, Rev. 2.1, Aug. 2007
TLE6258-2G
L I N T r a n s c e i v e r
A u t o m o t i v e P o w e r

Related parts for TLE 6258-2G

TLE 6258-2G Summary of contents

Page 1

TLE6258- Data Sheet, Rev. 2.1, Aug. 2007 ...

Page 2

... Infineon Technologies Office. Infineon Technologies components may be used in life-support devices or systems only with the express written approval of Infineon Technologies failure of such components can reasonably be expected to cause the failure of that life-support device or system or to affect the safety or effectiveness of that device or system. Life support devices or systems are intended to be implanted in the human body or to support and/or maintain and sustain and/or protect human life ...

Page 3

LIN Transceiver Features • Single-wire transceiver, suitable for LIN protocol • Compatible to LIN specification 1.2, 1.3 and 2.0 • Compatible to ISO 9141 functions • Transmission rate kBaud • Very low current consumption in stand-by mode ...

Page 4

Figure 1 Pin Configuration (top view) Table 1 Pin Definitions and Functions Pin No. Symbol Function 1 RxD Receive data output; integrated pull-up, LOW in dominant state 2 ENN Enable not input; integrated 30 kΩ pull-up, transceiver in normal operation ...

Page 5

V S Ω Output Stage 6 Bus Figure 2 Functional Block Diagram Data Sheet TL E6258 -2G M ode C ontrol D river T em p.- Protection R eceiver 5 TLE6258- Ω ...

Page 6

Application Information ENN High 1) After wake-up via bus 3) After start up Figure 3 State Diagram For fail safe reasons the TLE6258-2G has already a pull-up resistor of 30 kΩ implemented. To achieve the required timings for ...

Page 7

Table 2 Absolute Maximum Ratings Parameter Voltages Supply voltage Battery supply voltage Bus input voltage Bus input voltage Logic voltages at EN, TxD, RxD Electrostatic discharge V voltage at , Bus S Electrostatic discharge voltage Temperatures Junction temperature Note: Maximum ...

Page 8

Table 4 Electrical Characteristics V 4.5 V < < 5.5 V; 6.0 V < CC °C; all voltages with respect to ground; positive current flowing into pin; unless otherwise specified. Parameter Current Consumption Current consumption Current consumption Current consumption Current ...

Page 9

Table 4 Electrical Characteristics (cont’d) V 4.5 V < < 5.5 V; 6.0 V < CC °C; all voltages with respect to ground; positive current flowing into pin; unless otherwise specified. Parameter Enable Not Input (pin ENN) HIGH level input ...

Page 10

Table 4 Electrical Characteristics (cont’d) V 4.5 V < < 5.5 V; 6.0 V < CC °C; all voltages with respect to ground; positive current flowing into pin; unless otherwise specified. Parameter Bus Receiver Receiver threshold voltage, recessive to dominant ...

Page 11

Table 4 Electrical Characteristics (cont’d) V 4.5 V < < 5.5 V; 6.0 V < CC °C; all voltages with respect to ground; positive current flowing into pin; unless otherwise specified. Parameter Dynamic Transceiver Characteristics Falling edge slew rate Rising ...

Page 12

Table 4 Electrical Characteristics (cont’d) V 4.5 V < < 5.5 V; 6.0 V < CC °C; all voltages with respect to ground; positive current flowing into pin; unless otherwise specified. Parameter Wake-up delay time Delay time for mode change ...

Page 13

C Bus Figure 4 Test Circuits V TxD V CC GND V Bus V S GND V RxD V CC GND Figure 5 Timing Diagram for Dynamic Characteristics Data Sheet V ENN S 100 nF TxD RxD ...

Page 14

Application V LIN Bus Bat M aster Node + 22 µF Slave N ode + 22 µF Figure 6 Application Circuit Data Sheet TL E6258 - 100 Ω Bus ...

Page 15

Package Outlines 1.27 +0.1 2) 0.41 -0.06 0 -0.2 Index Marking 1) Does not include plastic or metal protrusion of 0.15 max. per side 2) Lead width can be 0.61 max. in dambar area ...

Page 16

Revision History Version Date Rev. 2.1 2007-08-08 RoHS-compliant version of the TLE6258-2G Data Sheet Changes • All pages: Infineon logo updated • Page 3: added “AEC qualified” and “RoHS” logo, “Green Product (RoHS compliant)” and “AEC qualified” statement added to ...

Related keywords