NS9W153AM Nichia, NS9W153AM Datasheet - Page 6

• Manufacturer Part Number: NS9W153AM
• Manufacturer: Nichia

Specifications of NS9W153AM

• Size Lxwxh (mm): 4.0x4.0x0.85
• Lumi-nous Inten-sity Typ(cd): 46
• Lumi-nous Flux Typ(lm)): 140.0
• Forward Voltage Vf(v) Typ: 8.80
• Forward Voltage Vf(v) Max: 10.00
• Directivity (degree): 120
• If (ma): 120
• Mounting Style: Through Hole

SOLDERING
• Recommended Reflow Soldering Condition(Lead-free Solder)
● Recommended Soldering Pad Pattern
* This LED is designed to be reflow soldered on to a PCB. If dip soldered or hand soldered,
* Reflow soldering must not be performed more than twice.
* Avoid rapid cooling. Ramp down the temperature gradually from the peak temperature.
* Nitrogen reflow soldering is recommended. Air flow soldering conditions can cause optical degradation,
* Since the silicone used in the encapsulating resin is soft, do not press on the encapsulant resin.
* Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable,
* When soldering, do not apply stress to the LED while the LED is hot.
Nichia cannot guarantee its reliability.
caused by heat and/or atmosphere.
Pressure can cause nicks, chip-outs, encapsulant delamination and deformation, and wire breaks, decreasing reliability.
a hot plate should be used.
It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
1 to 5°C per sec
Pre-heat
180 to 200°C
120sec Max
60sec Max
Above 220°C
4.1
0.6
260°C Max
10sec Max
(単位 Unit: mm)
5