M25PE40-VMP6TP Numonyx, B.V., M25PE40-VMP6TP Datasheet - Page 23

• Manufacturer Part Number: M25PE40-VMP6TP
• Description: 4 Mbit, page-erasable serial Flash memory with byte alterability, 75 MHz SPI bus, standard pinout
• Manufacturer: Numonyx, B.V.

M25PE40
6.3
Read Identification (RDID)
The Read Identification (RDID) instruction allows the 8-bit manufacturer identification to be
read, followed by two bytes of device identification. The manufacturer identification is
assigned by JEDEC, and has the value 20h for Numonyx. The device identification is
assigned by the device manufacturer, and indicates the memory type in the first byte (80h),
and the memory capacity of the device in the second byte (13h).
Any Read Identification (RDID) instruction while an Erase or Program cycle is in progress, is
not decoded, and has no effect on the cycle that is in progress.
The device is first selected by driving Chip Select (S) Low. Then, the 8-bit instruction code
for the instruction is shifted in. This is followed by the 24-bit device identification, stored in
the memory, being shifted out on Serial Data output (Q), each bit being shifted out during
the falling edge of Serial Clock (C).
The instruction sequence is shown in
The Read Identification (RDID) instruction is terminated by driving Chip Select (S) High at
any time during data output.
When Chip Select (S) is driven High, the device is put in the Standby Power mode. Once in
the Standby Power mode, the device waits to be selected, so that it can receive, decode and
execute instructions.
Table 6.
Figure 9.
S
C
D
Q
Manufacturer identification
0
High Impedance
Read Identification (RDID) Data-out sequence
Read Identification (RDID) instruction sequence and data-out sequence
20h
1
2
Instruction
3
4
5
6
7
MSB
Manufacturer identification
8
Figure
9 10 11 12 13 14 15
Memory type
80h
9.
Device identification
MSB
15 14 13
16 17 18
Device identification
Memory capacity
3
28 29 30 31
2
13h
1
0
Instructions
AI06809b
23/62