GB128128ANGAANUA-V01 Jewel Hill Electronic Co., Ltd., GB128128ANGAANUA-V01 Datasheet - Page 23

• Manufacturer Part Number: GB128128ANGAANUA-V01
• Description: SPECIFICATIONS FOR LCD MODULE
• Manufacturer: Jewel Hill Electronic Co., Ltd.

11. Using LCD modules
11.1 LIQUID CRYSTAL DISPLAY MODULES
LCD is composed of glass and polarizer. Pay attention to the following items when handling.
(1) Please keep the temperature within specified range for use and storage. Polarization degradation,
(2) Do not touch, push or rub the exposed polarizers with anything harder than a HB pencil lead (glass,
(3) N-hexane is recommended for cleaning the adhesives used to attach front/rear polarizers and
(4) When the display surface becomes dusty, wipe gently with absorbent cotton or other soft material
(5) Wipe off saliva or water drops immediately, contact with water over a long period of time may
(6) Avoid contacting oil and fats.
(7) Condensation on the surface and contact with terminals due to cold will damage, stain or
(8) Do not put or attach anything on the display area to avoid leaving marks on.
(9) Do not touch the display with bare hands. This will stain the display area and degrade insulation
(10)As glass is fragile, it tends to become or chipped during handling especially on the edges. Please
11.2 INSTALLING LCD MODULE
Attend to the following items when installing the LCM.
(1) Cover the surface with a transparent protective plate to protect the polarizer and LC cell.
(2) When assembling the LCM into other equipment, the spacer to the bit between the LCM and the
11.3 ELECTRO-STATIC DISCHARGE CONTROL
discharge as for an ordinary CMOS IC.
GB128128A
Since this module uses a CMOS LSI, the same careful attention should be paid for electrostatic
bubble generation or polarizer peel-off may occur with high temperature and high humidity.
tweezers, etc).
reflectors made of organic substances, which will be damaged by chemicals such as acetone,
toluene, toluene, ethanol and isopropyl alcohol.
like chamois soaked in petroleum ether. Do not scrub hard to avoid damaging the display surface.
cause deformation or color fading.
polarizers. After products are tested at low temperature they must be warmed up in a container
before coming is contacting with room temperature air.
between terminals (some cosmetics are determinate to the polarizers).
fitting plate should have enough height to avoid causing stress to the module surface, refer to the
individual specifications for measurements. The measurement tolerance should be ±0.1mm.
avoid dropping or jarring.
VER: 4.0
JEWEL HILL ELECTRONIC CO.,LTD.
- 22 -
Issue date: 2006/07/03