ND12S0A0V50PNFA Delta Electronics, Inc., ND12S0A0V50PNFA Datasheet - Page 9

• Manufacturer Part Number: ND12S0A0V50PNFA
• Description: Delphi Nd Series Non-isolated Point Of Load Dc/dc Power Modules 12vin, 0.9v~3.63vout, 50aout
• Manufacturer: Delta Electronics, Inc.

FEATURES DESCRIPTIONS (CON.)
The output can also be set by an external voltage
connected to trim pin as shown in Figure 28
Figure 28: output voltage trim with voltage source
To use voltage trim, the trim equation for the ND50 is
(please refer to Fig.28):
Vout is the desired output voltage
Vt is the external trim voltage
Rs is the resistance between Trim and Ground (in KΩ)
Rt is the resistor to be defined with the trim voltage (in KΩ)
Below is an example about using this voltage trim equation:
Example:
If Vt=1.25V, desired Vout=2.5V and Rs=1kΩ
Power Good
The converter provides an open collector signal called
Power Good. This output pin uses positive logic and is
open collector. This power good output is ale to sink 5mA
and set high when the output is within
point. The power good signal is pulled low when output is
not within ±10% of Vout or Enable is OFF.
DS_ND12S10A_07172008
±10% of output set
Output Capacitance
an external output capacitor(min 680uF) is required for
stable operation.
Voltage Margining Adjustment
Output voltage margin adjusting can be implemented in
the ND modules by connecting a resistor, R
the Trim pin to the Ground for margining up the output
voltage. Also, the output voltage can be adjusted lower by
connecting a resistor, R
voltage source Vt. Figure 29 shows the circuit
configuration for output voltage margining adjustment.
Figure 29: Circuit configuration for output voltage margining
Reflected Ripple Current and Output Ripple and
Noise Measurement
The measurement set-up outlined in Figure 30 has been
used for both input reflected/ terminal ripple current and
output voltage ripple and noise measurements on ND
series converters.
Cs=270μF*1, Ltest=1.4uH, Cin=270μF*2. Cout=680uF*4
Figure 30: Input reflected ripple/ capacitor ripple current and
output voltage ripple and noise measurement setup for ND50
margin-down
, from the Trim pin to the
margin-up
, from
9