UB800-18GM40-E4-V1 Pepperl+Fuchs, UB800-18GM40-E4-V1 Datasheet - Page 3

• Manufacturer Part Number: UB800-18GM40-E4-V1
• Description: Ultrasonic Sensor
• Manufacturer: Pepperl+Fuchs

Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group • Tel.: Germany [phone] • USA [phone] • Singapore [phone] • Internet http://www.pepperl-fuchs.com
TEACH-IN switching point, normally-open function
TEACH-IN switching point, normally-closed function
TEACH-IN detection of objects presence
Default setting of switching points
LED Displays
Installation conditions
•
•
•
•
•
•
•
•
•
•
•
•
•
A1 = blind range, A2 = nominal distance
If the sensor is installed at places, where the environment temperature can fall below 0 °C, for the sensors fixation, one of the
mounting flanges BF18, BF18-F or BF 5-30 must be used.
In case of direct mounting of the sensor in a through hole using the steel nuts, it has to be fixed at the middle of the housing
thread. If a fixation at the front end of the threaded housing is required, plastic nuts with centering ring (accessories) must be
used.
Displays in dependence on operating mode
TEACH-IN switching point:
Object detected
No object detected
Object uncertain (TEACH-IN invalid)
Normal operation
Fault
Ultrasonic sensor
Set target to far switching point
TEACH-IN switching point A1 with -U
Set target to near switching point
TEACH-IN switching point A2 with +U
Cover sensor with hand or remove all objects from sensing range
TEACH-IN switching point A1 with -U
Set target to near switching point
TEACH-IN switching point A1 with -U
Cover sensor with hand or remove all objects from sensing range
TEACH-IN switching point A2 with +U
Cover sensor with hand or remove all objects from sensing range
TEACH-IN switching point A1 with -U
TEACH-IN switching point A2 with +U
B
B
B
B
B
B
B
Red LED
flashes
On
on
off
off
Switching state
Previous state
Yellow LED
flashes
off
off
Copyright Pepperl+Fuchs, Printed in Germany
UB800-18GM40-E4-V1
3