IKCS12G60DC Infineon Technologies Corporation, IKCS12G60DC Datasheet - Page 6

• Manufacturer Part Number: IKCS12G60DC
• Description: Control Integrated Power System Cipos?
• Manufacturer: Infineon Technologies Corporation

Pin Description
Pin Assignment
/HIN1,2,3 and /LIN1,2,3 (Low side and high
side control pins, Pin 15 - 20)
These pins are active low and they are
responsible for the control of the integrated IGBT
The Schmitt-trigger input threshold of them are
Figure 2: Input pin structure
Data Sheet
Pin Number
10
11
12
13
14
15
16
17
18
19
20
21
22
23
1
2
3
4
5
6
7
8
9
Pin Name
VB3
W,VS3
na
VB2
V,VS2
na
VB1
U,VS1
na
V+
na
Sh
TEMP
VDD
/HIN1
/HIN2
/HIN3
/LIN1
/LIN2
/LIN3
EN,
/FAULT
ITRIP
VSS
high side floating IC supply voltage
motor output W, high side floating IC supply offset voltage
none
high side floating IC supply voltage
motor output V, high side floating IC supply offset voltage
none
high side floating IC supply voltage
motor output U, high side floating IC supply offset voltage
none
positive bus input voltage
none
closed low side emitter with internal shunt
temperature control
IC main supply +15V
input gate driver high side 1/U
input gate driver high side 2/V
input gate driver high side 3/W
input gate driver low side 1/U
input gate driver low side 2/V
input gate driver low side 3/W
input logic enable,
indicates over-current and under-voltage (negative logic, open-drain output)
input overcurrent shutdown
IC negative supply
6/18
such to guarantee LSTTL and CMOS compatibility
down to 3.3V controller outputs. Pull-up resistor of
about 75 kOhm is internally provided to pre-bias
inputs during supply start-up and a zener clamp is
provided for pin protection purposes. Input
schmitt-trigger and noise filter provide beneficial
noise rejection to short input pulses.
It is recommended for proper work of CIPOS™
not to provide input pulse-width lower than 1us.
The integrated gate drive provides additionally a
shoot through prevention capability which avoids
the simultaneous on-state of two gate drivers of
the same leg (i.e. HO1 and LO1, HO2 and LO2,
HO3 and LO3).
Pin Description
CIPOS™ IKCS12G60DA
Rev. 2.3, March 2009
IKCS12G60DC