LTL2P3TGK6 LiteOn Technology Corp., LTL2P3TGK6 Datasheet - Page 3

• Manufacturer Part Number: LTL2P3TGK6
• Description: Thru-hole Led Lamps 5mm Round Ingan Pure Green Ltl2p3tgk6
• Manufacturer: LiteOn Technology Corp.

NOTE: 1. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE
Part No. : LTL2P3TGK6
BNS-OD-C131/A4
Electrical / Optical Characteristics at T
Luminous Intensity
Viewing Angle
Dominant Wavelength
Spectral Line Half-Width
Forward Voltage
Reverse Current
2. θ
3. The dominant wavelength, λd is derived from the CIE chromaticity diagram and represents the single
4. Iv classification code is marked on each packing bag.
5. The Iv guarantee should be added ±15 ﹪ tolerance.
6. Precautions in handling:
7. Caution in ESD:
eye-response curve.
wavelength which defines the color of the device.
• When soldering, leave 2mm of minimum clearance from the resin to the soldering point.
• Dipping the resin to solder must be avoided.
• Correcting the soldered position after soldering must be avoided.
• In soldering, do not apply any stress to the lead frame particularly when heated.
• When forming a lead, make sure not to apply any stress inside the resin.
• Lead forming must be done before soldering.
• It is necessary to cut the lead frame at normal temperature.
Static Electricity and surge damages the LED. It is recommend to use a wrist band or anti-electrostatic
glove when handling the LED. All devices, equipment and machinery must be properly grounded.
1/2
Parameter
is the off-axis angle at which the luminous intensity is half the axial luminous intensity.
LITE-ON TECHNOLOGY CORPORATION
Symbol
2θ
∆λ
V
I
λ
I
V
R
1/2
d
F
P r o p e r t y o f L i t e - O n O n l y
1900
Min.
A
=25℃
4500
Typ.
525
3.5
15
35
Max.
100
4.0
Page : 3
Unit
mcd
deg
nm
nm
µA
V
I
Note 1,5
Note 2 (Fig.6)
Note 3
I
V
F
F
R
Test Condition
= 20mA
= 20mA
= 5V
of
10