P6002A Teccor Electronics, Inc., P6002A Datasheet - Page 187
![no-image](/images/no-image-200.jpg)
P6002A
Manufacturer Part Number
P6002A
Description
solid state crowbar devices
Manufacturer
Teccor Electronics, Inc.
Datasheet
1.P6002A.pdf
(212 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
P6002AA
Manufacturer:
Littelfuse
Quantity:
45 000
Company:
Part Number:
P6002AA MCL
Manufacturer:
Littelfuse
Quantity:
45 000
Company:
Part Number:
P6002AAL
Manufacturer:
Littelfuse
Quantity:
45 000
Company:
Part Number:
P6002AB
Manufacturer:
Littelfuse
Quantity:
45 000
Company:
Part Number:
P6002AB MCL
Manufacturer:
Littelfuse
Quantity:
45 000
- Current page: 187 of 212
- Download datasheet (2Mb)
TeleLink Fuse Soldering
© 2002 Teccor Electronics
SIDACtor
®
Data Book and Design Guide
For wave soldering a TeleLink fuse, the following temperature and time are recommended:
• Reservoir temperature of 260 °C (500 °F)
• Time in reservoir — three seconds maximum
For infrared, the following temperature and time are recommended:
• Temperature of 240 °C (464 °F)
• Time — 30 seconds maximum
Hand soldering is not recommended for this fuse because excessive heat can affect the
fuse performance. Hand soldering should be used only for rework and low volume samples.
Note the following recommendations for hand soldering:
• Maximum tip temperature of 240 °C (464 °F)
• Minimize the soldering time at temperature to achieve the solder joint. Measure the fuse
• Inspect the solder joint to ensure an adequate solder fillet has been produced without
resistance before and after soldering. Any fuse that shifts more than ±3% should be
replaced. An increase in resistance above this amount increases the possibility of a
surge failure, and a decrease in resistance may cause low overloads to exceed the
maximum opening times.
any cracks or visible defects.
5 - 25
TeleLink Fuse Soldering
http://www.teccor.com
+1 972-580-7777
Related parts for P6002A
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![D6015](/images/no-image3.png)
Part Number:
Description:
Power Rectifiers 15-20 Amp in TO-220AB Package
Manufacturer:
Teccor Electronics, Inc.
![D6035J](/images/no-image3.png)
Part Number:
Description:
22A Iout, 600V Vrrm General Purpose Silicon Rectifier
Manufacturer:
Teccor Electronics, Inc.
![P6002ZC](/images/no-image3.png)
Part Number:
Description:
275 V, four-port longitudinal two-chip protector
Manufacturer:
Teccor Electronics, Inc.
Datasheet:
![S4001L](/images/no-image3.png)
Part Number:
Description:
SCRs 1-70 AMPS NON-SENSITIVE GATE
Manufacturer:
Teccor Electronics, Inc.
Datasheet:
![S4003LS1](/images/no-image3.png)
Part Number:
Description:
400V V[drm] Max., 3.0A I[T] Max. Silicon Controlled Rectifier
Manufacturer:
Teccor Electronics, Inc.
![S4003M](/images/no-image3.png)
Part Number:
Description:
Silicon COntrolled Rectifier 1-70 Amps
Manufacturer:
Teccor Electronics, Inc.
![S4004F2](/images/no-image3.png)
Part Number:
Description:
400V V[drm] Max., 4.0A I[T] Max. Silicon Controlled Rectifier
Manufacturer:
Teccor Electronics, Inc.
![S4006LS2V](/images/no-image3.png)
Part Number:
Description:
Sensitive SCR
Manufacturer:
Teccor Electronics, Inc.
Datasheet:
![S2006FS221V](/images/no-image3.png)
Part Number:
Description:
Thyristor Product Catalog
Manufacturer:
Teccor Electronics, Inc.
Datasheet:
![EC103E3](/images/no-image3.png)
Part Number:
Description:
Thyristor, 500V 0.8A IGT<500UA, Thyristor, high gate sensivity
Manufacturer:
Teccor Electronics, Inc.
Datasheet:
![EC103E1](/images/no-image3.png)
Part Number:
Description:
Thyristor, 500V 0.8A IGT<12UA, Thyristor, high gate sensivity
Manufacturer:
Teccor Electronics, Inc.
Datasheet:
![EC113M](/images/no-image3.png)
Part Number:
Description:
Sensitive SCRs (0.8 - 10 Amps)
Manufacturer:
Teccor Electronics, Inc.
Datasheet: