S1D15714D00B000 Epson Company, S1D15714D00B000 Datasheet - Page 47

• Manufacturer Part Number: S1D15714D00B000
• Description: a single chip MLS driver
• Manufacturer: Epson Company

S1D15714 Series
(4) How to change the duty
Note:
(5) Refresh
It is recommended that the operating modes and display contents be refreshed periodically to prevent the effect of
unexpected noise.
44
* In the above sequence, the display disappears for the time from Power Save ON to Power Save OFF + about
350ms (in case of frame frequency 80Hz). When the Duty Set Command is executed while the liquid
crystal display is on, there may occur the trouble that the display blinks momentarily. Observe the above
sequence strictly.
Function setup by command entry (set by users)
Function setup by command entry (set by users)
Function setup by command entry (set by users)
Function setup by command entry (set by users)
Function setup by command entry (set by users)
(24) Power save ON
(23) Discharge ON
(23) Discharge OFF
(24) Power save OFF
(1) Display OFF
Function setup by command entry (set by users)
When the n-line reversing command is used :
(22) Electronic volume
(18) Built-in oscillator circuit frequency select
(14) Duty set
(12) n-line reverse drive register set
End of duty change
A desired state
Set all commands to the ready state
(Including default state setting.)
Refreshing of DRAM
A desired state
EPSON
Secure an interval of
30ms or more between
“discharge ON” to
“discharge OFF”.
Rev. 1.0