EB04 Apex Microtechnology Corporation, EB04 Datasheet - Page 3

• Manufacturer Part Number: EB04
• Description: Motion Control
• Manufacturer: Apex Microtechnology Corporation

PACKAGE
SPECIFICATIONS
INPUT
the half bridge. A logic level high turns on the FET and
low turns it off. A common shut down input turns off all
FETs when high.
2/3 V
interfaces with CMOS or HCMOS provided that the Vdd for
the logic family and the EB04 are the same.
the TTL gates driving the EB04, and Vdd for the EB04 is the
same supply as V
and all other inputs low, insuring that all outputs are off.
However, input impedance is 50k on all inputs; therefore if
one input is open circuited a high radiated noise level could
spuriously turn on a FET.
DIP9 PACKAGE
APEX MICROTECHNOLOGY CORPORATION • TELEPHONE [phone] • FAX [phone] • ORDERS [phone] • EMAIL [e-mail]
A logic level input independently controls each FET in
All inputs are Schmitt triggers with the upper threshold at
TTL families may be used if a pull-up to Vcc is added to
An open signal connector pulls the shut down input high
dd
and the lower threshold at 1/3 V
cc
for the TTL family.
dd
. This comfortably
OUTPUT
bridge. Separate HV supply, source, and HV return lines are
provided for each section.
saturation voltage is 1.9V maximum.
When switching an inductive load this diode will conduct, and
the drop at 5A will be 1.9V maximum.
Each output section consists of a switching mode FET half
The FETs are conservatively rated to carry 5A. At 5A the
Each FET has an intrinsic diode connected in anti-parallel.
ALTERNATE UNITS ARE [MM]
DIMENSIONS ARE IN INCHES
WEIGHT: 69 g or 2.4 oz
EB04
3