ATA5771 ATMEL Corporation, ATA5771 Datasheet - Page 30

• Manufacturer Part Number: ATA5771
• Manufacturer: ATMEL Corporation

3. General Description
4. Functional Description
4.1
4.2
4
ASK Transmission
FSK Transmission
T5753
This fully integrated PLL transmitter allows particularly simple, low-cost RF miniature transmit-
ters to be assembled. The VCO is locked to 32 f
315 MHz transmitter. All other PLL and VCO peripheral elements are integrated.
The XTO is a series resonance oscillator so that only one capacitor together with a crystal con-
nected in series to GND are needed as external elements.
The crystal oscillator together with the PLL needs typically < 3 ms until the PLL is locked and the
CLK output is stable. There is a wait time of
and the PA is switched on.
The power amplifier is an open-collector output delivering a current pulse which is nearly inde-
pendent from the load impedance. The delivered output power is hence controllable via the
connected load impedance.
This output configuration enables a simple matching to any kind of antenna or to 50 . A high
power efficiency of = P
load impedance of Z
If ENABLE = L and the PA_ENABLE = L, the circuit is in standby mode consuming only a very
small amount of current so that a lithium cell used as power supply can work for several years.
With ENABLE = H the XTO, PLL and the CLK driver are switched on. If PA_ENABLE remains L
only the PLL and the XTO is running and the CLK signal is delivered to the microcontroller. The
VCO locks to 32 times the XTO frequency.
With ENABLE = H and PA_ENABLE = H the PLL, XTO, CLK driver and the power amplifier are
on. With PA_ENABLE the power amplifier can be switched on and off, which is used to perform
the ASK modulation.
The T5753 is activated by ENABLE = H. PA_ENABLE must remain L for typically
the CLK signal can be taken to clock the microcontroller and the output power can be modulated
by means of Pin PA_ENABLE. After transmission PA_ENABLE is switched to L and the micro-
controller switches back to internal clocking. The T5753 is switched back to standby mode with
ENABLE = L.
The T5753 is activated by ENABLE = H. PA_ENABLE must remain L for typically
the CLK signal can be taken to clock the microcontroller and the power amplifier is switched on
with PA_ENABLE = H. The chip is then ready for FSK modulation. The microcontroller starts to
switch on and off the capacitor between the XTAL load capacitor and GND with an open-drain
output port, thus changing the reference frequency of the PLL. If the switch is closed, the output
frequency is lower than if the switch is open. After transmission PA_ENABLE is switched to L
and the microcontroller switches back to internal clocking. The T5753 is switched back to
standby mode with ENABLE = L.
The accuracy of the frequency deviation with XTAL pulling method is about ±25% when the fol-
lowing tolerances are considered.
Load
= (255 + j192)
out
/(I
S,PA
V
S
) of 40% for the power amplifier results when an optimized
is used at 3 V supply voltage.
3 ms until the CLK is used for the microcontroller
XTAL
hence a 9.8438 MHz crystal is needed for a
4510I–RKE–02/07
3 ms, then
3 ms, then