ARX4435 Aeroflex Circuit Technology, ARX4435 Datasheet - Page 2
![no-image](/images/no-image-200.jpg)
ARX4435
Manufacturer Part Number
ARX4435
Description
Arx4435 Transceiver For MacaIR H009 Specification
Manufacturer
Aeroflex Circuit Technology
Datasheet
1.ARX4435.pdf
(6 pages)
Aeroflex Circuit Technology
an overriding “INHIBIT” input returns the output
impedance to a high state. A logic “1” applied to the
“INHIBIT” takes priority over the condition of the data
inputs and disables the transmitter. (See Transmitter
Logic Waveforms, Figure 1.)
harmonics above 1 mHz to meet H 009 Macair speci-
fications. The transmitter may be safely operated for
an indefinite period with the output short circuited at
100% duty cycle.
Receiver
data at the input and produces two TTL signals at the
output. The outputs are DATA and DATA, and repre-
DATA IN
DATA IN
INHIBIT
LINE TO LINE
LINE TO LINE
Rx DATA OUT
Rx DATA OUT
Notes: 1. Data and DATA inputs must be complementry waveforms or 50% duty cycle average, with no delays between them, and in the same state during
The transmitter utilizes an active filter to suppress
The Receiver section accepts bi-phase differential
OUTPUT
Figure 1 - Transmitter Logic Waveforms
Figure 2 - Receiver Logic Waveforms
INPUT
2. Region 1 ; no output signal, High Z state, (Receive Mode), Region 2; No Output signal, Low Z state, (Terminate Mode), Region 3, Transmitter signal
the off time (both high and low).
on, low Z.
Note
Region 1
:
Waveforms shown are for normally low devices. For normally high receiver output
level
devices, the receiver outputs are swapped as shown by the dashed lines
2
3
2
sent positive and negative excursions of the input
beyond a pre-determined threshold.(See Receiver
Logic Waveforms, Figure 2.)
data bus signals exceeding 1.05 Volts P-P and reject
signals less than 0.6 volts P-P when used with a 1:1
turns ratio transformer. (See Figure 5 for transformer
data and typical connection.)
and DATA outputs. If unused, a 2K pull-up to +5 Volts
is recommended
The internal threshold is nominally set to detect
A low level at the Strobe input inhibits the DATA
Note overlap
SCD4435 REV B 2/3/99 Plainview NY (516) 694-6700