BHC-XL2M2TY Everlight Electronics Co., Ltd., BHC-XL2M2TY Datasheet - Page 9

• Manufacturer Part Number: BHC-XL2M2TY
• Description: Chip LED (1.0mm Height)
• Manufacturer: Everlight Electronics Co., Ltd.

1. Over-current-proof
2. Storage
3. Soldering Condition
3.1 Pb-free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
Precautions For Use
Everlight Electronics Co., Ltd.
Device No:DSE-171-B02
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package: The LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 After opening the package: The LED's floor life is 1 year under 30℃ or less and 60% RH or less.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
Customer must apply resistors for protection , otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
If unused LEDs remain, it should be stored in moisture proof packages.
storage time, baking treatment should be performed using the following conditions.
Baking treatment : 60±5℃ for 24 hours.
EVERLIGHT ELECTRONICS CO.,LTD.
http://www.everlight.com
Prepared date: 25-Oct-2007
17-21/BHC-XL2M2TY/3T
Prepared by: Zhouhua
Rev. 2
Page: 9 of 10